Southbend sb1018 owner manual Loosen the belt tension bolt shown in Figure

Model SB1018 P R E P A R A T I O N For Machines Mfg. Since 8/09

7.Insert the axle through the holes in the base assembly, then slide the wheels over the axle and secure each with a cotter pin, as shown in Figure 13.

Axle

Base

Wheel

Cotter Pin

Figure 13. Wheel assembly.

8.Thread the leveling feet into the stand assembly, as shown in Figure 14. You can adjust these later as needed to level the bandsaw.

Leveling

Feet

Figure 14. Leveling feet.

9.With the help of another person, flip the stand assembly right-side up, then place the chip tray onto the stand, lining up the mounting holes.

10.With the help of another person, lift the bandsaw assembly and place it onto the stand assembly, lining up the mounting holes.

11.Secure the bandsaw to the stand with four M12-1.75 x 25 hex bolts and 12mm flat washers, as shown in Figure 15.

Hex Bolts

(2 of 4 Shown)

(Handwheel Not Yet

Installed)

Figure 15. Mounting bandsaw to stand.

12. Loosen the belt tension bolt shown in Figure

16.

(Pulley Cover Not	Belt Tension Bolt
Yet Installed)

Figure 16. Belt tension bolt location.

-16-