Model SB1018 | P R E P A R A T I O N | For Machines Mfg. Since 8/09 |
16.Remove the shipping strap hex bolt and strap with a 12mm wrench, as shown in Figure 21.
Figure 21. Removing shipping strap.
17.If you choose to use the deflector, position it as shown in Figure 22 (the deflector directs swarf from the cut and small workpieces into the chip tray when the cut is complete).
Power Connection
Electrocution or fire may occur if machine is ungrounded, incorrectly connected to power, or connected to an undersized circuit. Use a qualified electrician to ensure a safe power connection.
Once your machine is set up and assembled as previously described in this manual, it is ready to be connected to the power source.
•If you plan to use the machine at 110V, simply plug it into a receptacle on a 110V circuit that meets the requirements listed on Page 10.
•If you plan to use the machine at 220V, you will have to convert the machine for 220V. Refer to Electrical, beginning on Page 41.
Deflector
