Woodstock M1099 manual =XZ\gcXk, KfcfXXnfibg`\Z\fekfk\XZ\gcXk\1, `c

Df[\cD('00D]^J`eZ\/&'.

=XZ\gcXk\

The faceplate can be used to turn non-cylindrical parts or for off-center turning by clamping the workpiece to the faceplate.

Refer to the Dflek`e^:_lZbfi=XZ\gcXk\ procedures on GX^\(- to mount the faceplate.

KfcfX[Xnfibg`\Z\fekfk_\]XZ\gcXk\1

(% DISCONNECT POWER TO THE LATHE!

). Support the workpiece.

*% Slide the tailstock to the workpiece.

+% Lock the tailstock, then turn the tailstock quill so the dead center makes contact with the center point of your workpiece.

,% Lock the tailstock quill when sufficient pressure is applied to hold the workpiece in place.

Efk\1 ;\g\e[`e^fek_\nfibg`\Z\#jfd\X[[`k`feXc jlggfikdXpY\e\\[\[%

-%Secure the workpiece with a minimum of three inde- pendent clamping devices. Failure to follow this step may lead to deadly injury to yourself or bystanders.

Take into account rotation and the cutting forces applied to the workpiece when clamping to the face- plate. DXb\jli\pfliZcXdg`e^Xggc`ZXk`fen`ccefk

]X`c

.% Use a lower RPM when machining heavy eccentric workpieces.

Lj\ X cfn IGD n_\e

dXZ_`e`e^ _\Xmp \ZZ\eki`Z

nfibg`\Z\j2 FYa\Zkj k_ifne

]ifdXcXk_\ZXeZXlj\j\i`$

flj`ealipfi[\Xk_%

=`^li\(+% Faceplate installed.

Lj\ X d`e`dld f] k_i\\ `e[\g\e$ [\ek ZcXdg`e^ [\m`Z\j n_\e klie`e^ \ZZ\eki`Z nfibg`\Z\j% =X`cli\ kf gif$ m`[\ X[\hlXk\ ZcXdg`e^ n`cc ZXlj\ nfibg`\Z\kf\a\Zk%

FG<I8K@FEJ

-19-