Df[\cD('00D]^J`eZ\/&'.
9\ck8[aljkd\ekfi I\gcXZ\d\ek
<EK8E>C<D<EK?8Q8I; ;`jZfee\Zkk_`jcXk_\]ifdgfn\i Xe[nX`klek`cXccjg`ee`e^gXikj _Xm\ Zfd\ kf X Zfdgc\k\ jkfg Y\]fi\ pfl XZZ\jj k_\ Y\ck Xe[ glcc\pj% Fk_\in`j\ pfl dXp Y\ j\m\i\cp`eali\[
Kfi\gcXZ\fiX[aljkk_\M$Y\ckj#[fk_\j\jk\gj1
(% DISCONNECT POWER TO THE LATHE!
)% Open the side access door to expose the belt, pul- leys, and change gears.
—If the high range belt (=`^li\+() needs to be replaced, carefully roll the belt off of pulleys 8 and : and reinstall the new one.
—If the low range belt (=`^li\+)) needs to be replaced, use the 17mm wrench to loosen the tensioner pulley arm that holds the pulley and replace the belt on pulleys 9 and :% Hold the ten- sioner pulley against the new belt so the belt is tight, and tighten the tensioner pulley in place.
:
8
=`^li\+(%
:
9
Tensioner Pulley
=`^li\+)%
J<IM@:<