Woodstock M1099 manual @eZKi\Xj, Kfj\klgfi`eZki\X`e#fk\j\jk\gj1, -+ Kg@

Df[\cD('00D]^J`eZ\/&'.

FG<I8K@FEJ

@eZ_K_i\X[j

Use these steps to learn how to setup your lathe for inch threading. The example in =`^li\*+ shows lathe setup for cutting 64 TPI (Teeth Per/Inch) thread.

Kfj\klg]fi`eZ_k_i\X[`e^#[fk_\j\jk\gj1

(% DISCONNECT THE LATHE FROM POWER!

)% Turn the feed dials to the numeral and letter indi- cated by the chart in=`^li\*+.

*% Using the chart in=`^li\*+, gather the required change gears.

+% Open the side cover and use a 6mm hex wrench to loosen the lash adjuster (=`^li\*)) and swing the change gear assembly out of the way.

,% Remove the spindle E-clips and cap screw, lubricate, and swap out the change gears in the order shown on the chart in =`^li\*)%

-%Move the lash adjuster so the gear backlash is between 0.003" to 0.008", tighten the lash adjuster cap screw, and close the side cover.

.% Using a 5mm hex wrench, make sure the carriage lock is loose (=`^li\*().

;li`e^ k_i\X[`e^ b\\g pfli _Xe[ fe k_\ _Xc]$elk c\m\i i\X[p kf [`j\e^X^\ k_\_Xc]elkkfXmf`[gfk\ek`XcZXii`X^\& Z_lZbZiXj_%

=`^li\**% Thread dial chart and

thread dial.

/% The lathe is now setup for threading.

 Efk\1 =fi]Xjk\ik_i\X[`e^Xe[dXelXc ZXii`X^\i\klie#YXj\[fen_`Z_KG@ Y\`e^Zlk#i\]\ikfk_\@e[`ZXkfiKXYc\ `e =`^li\**kfbefn`]pflZXelj\ k_\k_i\X[[`XcjZXc\kfj_fnn_\ekf i\$\ek\ik_\k_i\X[dXelXccpX]k\i[`j$ \e^X^`e^k_\_Xc]elkc\m\i%

X

Y 4-+KG@

Inch

Thread

Chart

=`^li\*+% Inch threading setup.

-30-