Woodstock M1099 manual Gfn\i=\\IXk, Kfj\kXe\eX\k\gfn\i\\#fk\j\jk\gj1, Feed Chart

Df[\cD('00D]^J`eZ\/&'.

Gfn\i=\\[IXk\

Use these steps to learn how to setup your lathe for a power feed operation. The example in =`^li\*) shows lathe setup for a power feed rate of 0.012". Remember, the carriage direction is reversed when spindle rotation is reversed.

Kfj\kXe[\e^X^\k_\gfn\i]\\[#[fk_\j\jk\gj1

(% DISCONNECT LATHE FROM POWER!

)% Turn the feed dials to the numeral and letter indi- cated by the chart in=`^li\*).

*% Using the chart in=`^li\*), gather the required change gears.

+% Open the side cover and use a 6mm hex wrench to loosen the lash adjuster (=`^li\*)) and swing the change gear assembly out of the way.

,% Remove the spindle E-clips and cap screw, lubricate, and swap out the change gears in the order shown on the chart in =`^li\*)%

-%Move the lash adjuster so the gear backlash is between 0.003" to 0.008", tighten the lash adjuster cap screw, and close the side cover.

=\\[iXk\`jYXj\[fejg`e[c\IGD%GXp Zcfj\ Xkk\ek`fe kf k_\ ]\\[ iXk\ pfl _Xm\Z_fj\eXe[Y\i\X[pkf[`j\e^X^\ k_\ ZXii`X^\% =X`cli\ kf [f k_`j dXp ZXlj\ k_\ ZXii`X^\ kf ZiXj_ `ekf k_\ Z_lZb%

Carriage Lock

Cap Screw

Half Nut

Lever

=`^li\*(% Carriage lock and feed control.

FG<I8K@FEJ

.% Using a 5mm hex wrench, loosen the carriage lock (=`^li\*(), and use the half nut lever to engage and disengage the power feed when required.

+'			Feed Chart
	-'
).
		Change Gears

,-().

('+

4'%'()=\\[

Lash Adjuster
	Feed Dials

=`^li\*)% Power feed setup.

-29-