English
•Follow the mounting instructions carefully. Fasten the tool to the saw mounting brackets securely as instructed.
•DO NOT modify or use stand for operations for which it is unintended.
•DO NOT use the stand on uneven surfaces. DO NOT use the stand with the legs folded and stand sitting on the ground. The stand is designed to be used on a flat, stable surface.
ASSEMBLY
Attaching the Wheels and Axle
1. Attach | the | axle (A) to |
|
| |
the leg support (B) by |
|
| |||
aligning the |
|
| |||
holes. Ensure the long end |
|
| |||
of the axle is to the rear of | B | ||||
the stand as shown. Secure | |||||
|
| ||||
axle to | leg | support using A |
|
| |
two carriage bolts, washers |
|
| |||
and lock nuts provided. |
|
|
2. Place the wheels (C) on the axle and secure with washers and lock nuts as shown. Tighten wheel and axle nuts securely.
Attaching the
Kickstand
Insert the tube plugs (O) into the end of the kickstand tube (N). The groove in the tube plug should be facing down as shown. Be sure that the holes (P) in the tube plugs are in line with the holes (Q) in the kickstand tube before inserting the tube plugs.
Insertthekickstandtube(N)through | Q | |
the holes in the leg support (B) on | ||
N | ||
the | P | |
Be sure the kickstand is pointing |
| |
up when the stand is an upright |
| |
position. Secure the kickstand to | O | |
the beams (I) with the four M6 | ||
screws provided as shown (below, |
| |
left). |
|
The hex wrench may be stored in the end of the tube plug as shown for future use.
B N
Attaching the
Rubber Bumpers
M
Attach the two rubber bumpers (M) to the handle side leg support as shown using the M4 screws and lock nuts provided.
3