Cisco Systems SN 5428 manual Actuator/Button SFP Modules

Chapter 2 Installing the SN 5428 Storage Router

Installing SFP Modules

Actuator/Button SFP Modules

The actuator/button SFP module (see Figure 2-10) has a button that you must push in order to remove the SFP module from a port.

Figure 2-10 Actuator/Button SFP Module

63066

To insert the actuator/button SFP module into a port, line up the SFP module with the port and slide it in until the actuator/button clicks into place (see Figure 2-11). Be sure not to press the actuator/button as you insert the SFP module because you might inadvertently disengage the SFP module from the port.

Figure 2-11 Inserting an Actuator/Button SFP Module

73994

To remove an actuator/button SFP module from a port, perform the following steps:

Step 1 Gently press the actuator/button on the front of the SFP module until it clicks and the latch mechanism activates, releasing the SFP module from the port (see Figure 2-12).

	Cisco SN 5428 Storage Router Hardware Installation Guide
2-16	OL-4796-01