Cisco Systems MC-607 manual Basic Internet Access Bridging Configuration Example, MC-650

Configuring Subscriber-End Broadband Access Router Features

Subscriber-End Broadband Access Router Configuration Examples

•Power down the cable access router for approximately one minute and then power it back up so that the PC MAC address will be rediscovered and associated with the cable access router during the normal provisioning process. The PC might also need to be rebooted.

•Increase the value of the MAX CPE parameter in the cable access router DOCSIS configuration file so that it can accommodate the desired number of PCs. Reset the cable access router to force it to load the updated configuration file.

Subscriber-End Broadband Access Router Configuration Examples

To view the configuration of a Cisco uBR900 series cable access router, enter the show running-configcommand at the CLI prompt in global configuration mode.

This section provides examples of the following configurations:

•Basic Internet Access Bridging Configuration Example

•Basic Internet Access Routing Configuration Example

•IP Multicast Routing Configuration Example

•VoIP Bridging Using H.323v2 Configuration Example

•VoIP Routing Using H.323v2 Configuration Example

•NAT/PAT Configuration Example

•VoIP Bridging Using SGCP Configuration Example

•IPSec Configuration Example

•L2TP Configuration Example

Basic Internet Access Bridging Configuration Example

The following Cisco uBR900 series cable access router configuration supports a typical residential Internet-access, data-only subscriber:

Current configuration:

!

version 12.1 service config no service pad

service timestamps debug uptime service timestamps log uptime no service password-encryption

!

hostname uBR904

!

clock timezone - 4 ip subnet-zero

no ip routing

!

voice-port 0

!

voice-port 1

!

interface Ethernet0

ip address 172.16.1.40 255.255.0.0

Cisco IOS Multiservice Applications Configuration Guide

MC-650