9. Holdrodwithonehandandwitha 7/16 in. wrench or
pliers start screwing on ONE of the nuts only ATURN OR TWO ... screw on other nut the same way.
10.Using TWO 7/16 in. wrenches or pliers tighten both of the nuts.
11.Slide the bars so that screws are in the MIDDLE of the slotted holes.
12.Position rip fence over miter gauge groove, holding up the rear end while engaging front end with bar ...
lower fence onto table.
13.Raise blade all the way up.
14.Carefully move fence against blade.
15.Move front bar until "0" mark on rip scale is approximately at tip of pointer.
16.Move FRONT bar upwards until fence is approximately
1/32 in. above table ... tighten screw at left end of bar.
NOTE: Fold a piece of newspaper making 8 thicknesses and place between rip fence and table to act as a spacer. This will hold the fence off of the table approx. 1/32 in.
17.Adjust rear bar so that the fence is approximately 1/32 in. above table make sure it is square with fence guide bar rod ... tighten screw at end of bar.
18.Replace screws in rear of table extension ... be sure top surface of extension is PARALLEL to top surface of rear guide bar.
19.Move fence to RIGHT edge of table ... make sure it is approx. 1/32 in. above table at front and rear and tighten screws.
8THICKNESSES OF PAPER
8THICKNESSES OF PAPER
IO