Lay REAR FENCE GUIDE BAR on table to act as a
straightedge. If outer edge of extension is higher or lower than table surface;
A. Slightly loosen nuts holding bracket to extension using 7/t6 in. wrench.
B.Move end of extension up or down until outer edge is even with table surface ... check with GUIDE
BAR ... tighten nuts.
C.Recheck INNER edge of extension to make sure it has not moved ... readjust, if necessary.
INSTALLING RIP FENCE GUIDE BARS
\
t
\
\ \
1. From among the loose parts find the following hardware:
2 Hex. Head Screws, 5/16 in. - 18 x
4 Hex. Nuts, 5/16 in. - 18 (approx. dia. of hole 5/16 in.)
4 External Lockwashers, 5/16 in. (approx. dia. of hole 5/16 in.)
2 Spacers, 3/4 in. dia. x 1/2 in. long
2
2.Lay guide bars on table.
NOTE: The various holes in the bars allow them to be
repositioned | on the saw and also makes them adaptable |
|
|
|
|
|
|
|
|
| |||||||
to other | models, |
|
|
|
|
|
| SWITCH BRACKET | then | through | SIXTH | hole | in bar. | ||||
3. Insert | 1 | 1/2 | in. | long | screw | through the FIRST hole |
| Hold | them | in place | with | a piece | of masking | tape | from | ||
| the underside. |
|
|
|
|
|
| ||||||||||
from the | LEFT | IN | THE | FRONT | BAR ... | insert |
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
| |||||||||
another | 1 1/2 | in. | long | screw | through | LARGE | hole in | 4. | Place | spacers | on screws. |
|
|
|
| ||
|
|
|
|
|
|
|
|
| |||||||||
5.Insert bolts through holes in middle and on right side of front of saw table ... install Iockwashers and nuts.
DON'T SCREW NUTS ON ALL THE WAY, just get them started on the screws.
6.Remove the 3 screws from rear of table extension,
7.Insert 7/8 in. long screws in FIRST and THIRD holes of rear bar and attach to table the same way.
8° Insert ends of FENCE GUIDE BAR ROD through round holes at outer end of bars.
NOTE: The ends of the ROD are not threaded ... the SELF THREADING NUTS will cut threads on the rod as they are screwed on.