Craftsman 113.24181 owner manual Assembly, Turn the saw upside down, Nuts, Hex

ASSEMBLY

ATTACHgNG LEGS

1.Turn the saw upside down.

NOTE: DO NOT LAY IT ON THE FLOOR AS THIS

MAY SCRATCH THE TABLE SURFACE. PLACE IT ON STRIPS OF WOOD OR PARTS OF THE PACKING MATERIAL.

2.From among the loose parts, find the following hardware:

16 Hex. Head Screws, 5/16 in.- 18 x 5/8 in. long

16 Hex, Nuts, 5/16 in.-18 (approx. dia. of hole, 5/16 in.)

16 Hex. Head Screws, 1/4 in.-20 x 1/2 in. long

16 Hex. Nuts, 1/4 in.-20 (approx. dia. of hole, 1/4 in.) 8 Hex. Nuts, 1/2 in.--13 (approx. dia. of hole, 1/2 in.) 4 Leveling Feet

16 Lockwashers, 1/4 in. External Type (approx. dia. of hole, 1/4 in.)

16 Lockwashers, 5/16 in. External Type (approx. dia. of hole, 5/16 in.)

NOTE: The four stiffeners are identical. BE SURE TO

ATTACH THE SIDE STIFFENERS USING THE

OUTER HOLES ... ATTACH END STIFFENERS USING INNER HOLES.

3.Insert screws through legs then through stiffeners. Install Iockwashers and nuts. DO NOT TIGHTEN.

4.After all screws, washers and nuts are installed, tighten all nuts.

5.Install leveling feet.

6.Place saw in upright position.

LEG

END STIFFENER

;IDE STIFFENER

5/16 -18 x 5/8

j_LEVELING FOOT

NUTS, HEX.

I/2- _3

i..,_-.- LEG

END STIFFENER

SIDE STIFFENER

INNEREND

HOLESHOLES

Before proceeding with the assembly, the Table Insert and

Blade Squareness must be checked at this time.

CHECKING TABLE INSERT

2.Insert should be flush with table top. Check as shown - and adjust the four setscrewsas necessary.

3/32 IN.

SETSCREW WRENCH