Craftsman 113.24181 owner manual Aligning RIP Fence

Page 11

ALIGNING RIP FENCE

The fence should slide easily along the bars and always remain in alignment (parallel to sawblade and miter gauge grooves).

The alignment is maintained by a spring underneath the fence which bears against the front guide bar.

To move the fence, loosen the lock handle and grasp the fence with one hand at the front.

For very close adjustments, grasp the guide bar with both hands and move the fence with your thumbs.

Place fence on saw but DO NOT LOCK IT.

Move the REAR END of the fence slightly to the right or left ... when you release it, the fence should "spring'" back to its original position.

If it does not, the spring pressure must be INCREASED.

1.Loosen the screws.

2.Move Spring slightly toward front of fence.

Image 11

Contents 113.24181 Model noFor Power Tools Protection EYES, HANDS, FACE, EARS, Body For Table SawsLocation KickbacksWear Your Motor Specfications Electrical RequirementsContents Unpacking and Checking Contents NUTS, HEX AssemblyTurn the saw upside down Not Tighten Checking Blade Squareness to TableAttaching Table Extensions Insert Installing RIP Fence Guide BarsHoldrodwithonehandandwitha 7/16 in. wrench or Aligning RIP Fence HEX Screvs Lock Installing Blade GuardRip fence must be Parallel with the sawblade Setscrew Wrenches Space Eqljal to Approx Thicknesses of Paper Kerf WoodParallel ANTI-KICKBACK PawlsEtting to RN OW Your SAW ON-OFF SwitchAuxiliary Facing Limit StopsLeft RightRemove insert Removing and Installing SawbladeEXACT-I-CUT Push Stick and Push Block OperationWork Helpers CROSSCUTTING, Miter CUTTING, Bevel CuttingGroove CrosscuttingRepetitive Cutting ManufacturingEndanger Your Hands Miter CuttingBeve L Crosscutting Compound Miter CuttingKickback Bevel RippingPush Block Do not Back UP Reverse Feeding While ResawingCutti NG PAN ELS RabbetingMiter Gauge AdjustmentsTeeth Blade TILT, or Squareness Blade to TableStop Screw Outlet Before Maintaining or Lubricating Your SAW MaintenanceElevation Lock 3218 Miter GuageWorm and Teeth 22201Trouble Probable Cause Outlet Before TroubleshootingOr fails to come up TroubleProbable Cause Remedy20m Parts List for Craftsman 12-INCH Motorized Table SAWParts List for Craftsman 12-INCHMOTORIZED Table SAW Model Number 50A 2852 Parts LiST for Craftsman 12-INCH Motorized Table SAW 62581 Fence Assembly Box Assembly Control w/Nameplate Parts List for Raftsman 12-INCHMOTORIZED Table SAWRepair Service is Available AT Your Nearest Sears Store Complete Motor AssemblySTD See Wiring DIAGRAM,62325 Miter Gauge Assembly 62594 Guard Assembly Parts List for Craftsman 12-! NCH Motorized Table SAW62589 Table Extension Sears TAB LE SAW Service