6. Set up
SE2
SE3
SE4
■MOUNTING OF CUTTER BLADE
WARNING
The flange bolt shall be securely fixed. (Fixing torque: 266~434
1.Unscrew a flange bolt and remove flange washer (A).
2.Mount a cutter blade on flange washer (B) aligning its centre hole correctly with a projection of the washer. Holding the blade with flange washer (A), screw in the flange bolt.
(1) | Cutter blade | (2) | Flange bolt |
(3) | Flange washer (A) | (4) | Flange washer (B) |
3.Insert an attached bar (6mm diameter) to a hole on pulley cover as shown in the left Fig. Slowly turn the blade to find a hole on a belt pulley, and apply locking of the pulley.
4.Securely tighten the flange bolt with an attached eye wrench of 17mm diagonal size. (Specified torque: 266~434
(1) | Pulley cover | (2) | Cutter blade |
(3) | Bar | (4) | Flange bolt |
(5) | Eye wrench | (6) | Tighten |
IMPORTANT
These attached tools must be used also to remove the cutter blade.
■FITTING DUST HOSE AND DUST BAG
1.Connect an attached dust hose on an exhaust outlet behind a fan cover of the machine. Tighten the hose with a metal band securely.
2.Insert the end of the dust hose to the inlet of dust bag and securely fix with a cord on the bag.
(1) | Dust hose | (2) Metal band |
(3) | Dust bag | (4) Tying Cord |