RedMax HC510DV manual Storage,  31 

Page 31

10. Storage

WARNING

When discharging fuel, be careful not to spill fuel and completely wipe off if spilled. Also, securely close a cap of storage tank.

IMPORTANT

•In case the machine is left for long time, inside of the carburetor may be clogged and cause engine failure (starting failure or poor output power).

•During storage, make fuel tank cap loose. If it is tighten too much, cap packing may deform by temporal change.

1.Remove the dust hose and the dust bag from the body.

2.Open the dust bag fastener and remove internal dusts completely.

3.Remove debris and dirt on the machine body.

4.After discharging fuel from the fuel tank, start the engine and run until it stops.

5.Remove the spark plug and drop 1~2 cc of 2 cycle engine oil into the plug hole, then pull the starter rope for 2~3 times. After fitting the spark plug as original, pull the starter rope and stop at compression position.

6.Fully slack the tension of pulley drive belt.

7.Fully slack the tension of fan drive belt.

8.Dismount the cutter blade.

9.After applying appropriate cover on the machine, store it in an adequate place such as storage shelf, keeping moisture, dusts and children away.

31 

Image 31

Contents T2069-93110 HC510DVPage Contents Safety FirstParts location Specifications 4   5   6  Symbols on the machineFor safe operation Before Using the Machine 7   8  Working Gear and Clothing 9   10  Operation Safety PrecautionsAfter Using the SAW Maintenance Safety Precaution 11   12  Set upSE1 Change of Dust StopperDust hose Metal band Dust bag Tying Cord SE2 SE3 SE4 Mounting of Cutter BladeCutter blade Flange bolt Flange washer a Fitting Dust Hose and Dust BAGRecommended Mixing Ratio Gasoline 50OIL HOW to MIX FuelFuel  14 For Your Engine LIFE, Avoid Fueling the Unit 16  OperationOP1 OP2 Starting Engine CloseOP3 OP4 OP5 Safety lock Start setting button Throttle leverDecomp valve OFF SwitchOP6 Stopping EngineVertical Cutting OP7 OP8 Cutting OperationFor AN Efficient Cutting Operation Front guide Horizontal CuttingMA1 MaintenanceAIR Cleaner Air cleaner cover Top plate Felt filterNGK BPM8Y MA2MA3 Spark PlugBlade Drive Belt MA4 MA5 Cooling AIR Passage 22  MA6 MA7 MA8 MA9 Disassembling ProcedureBelt Exchange  24  Assembling Procedure 25  FAN Drive Belt Belt Tension Adjustment and ExchangeIdler pulley Belt adjustment plate Bolt Tighten Slacken MA14 26  Engine Adjustment MA15When adjusting, take the following steps MA15 27   28  Starter Rope ExchangeNotch MA19 MA20 MA21 30   31  StorageCheck Probable Causes Action Troubleshooting guide 32   33  Parts list 34  Cutter Unit HC510DV S/N 200101 and up 35   36  Power Unit 1 HC510DV S/N 200101 and up 37   38  Power Unit 2 HC510DV S/N 200101 and up 39   40  Carburetor HC510DV S/N 200101 and up 41  Accessories & Tool SET HC510DV S/N 200101 and upManufacturer’s warranty coverage Limited Warranty RedMax Garantie limitée