RedMax HC510DV manual MA2, MA3, Spark Plug, NGK BPM8Y, Fuel Filter

Page 21

9. Maintenance

MA2

0.6~0.7mm

MA3

or damaged.

Avoid dusts to penetrate into the engine when removing the air filter. Cover an air inlet with a cloth after removing the filter.

To keep the engine performance, change the air filter at every 20 hours of operation.

SPARK PLUG

WARNING

Do not touch the spark plug by bare hands immediately after stopping the engine. There is a danger of burn for its high temperature.

About every 25 hours of operation, remove the spark plug and clean contaminant on electrodes with a wire brush, etc.

Applicable gap between the electrodes is 0.6~0.7mm.

Use specified spark plug for exchange.

Specified Spark Plug:

NGK BPM8Y

IMPORTANT

Electrodes of the spark plug are contaminated by over sucking of fuel or by poor quality oil. This may cause the engine start difficult.

FUEL FILTER

About every 25 hours of operation, remove a fuel filter from the fuel tank and remove adhered debris. In case the filter is clogged, exchange with a new one.

Care should be taken not to bend a fuel pipe when setting the filter back into the tank.

(1) Fuel filter

IMPORTANT

In case the fuel filter is clogged or the fuel pipe is bent, engine speed may not increase or may become unstable.

21

Image 21
Contents T2069-93110 HC510DVPage Contents Safety FirstSpecifications Parts location 4   5   6  Symbols on the machineBefore Using the Machine For safe operation 7   8  Working Gear and Clothing 9   10  Operation Safety PrecautionsMaintenance Safety Precaution After Using the SAW 11  SE1 Set upChange of Dust Stopper  12 Cutter blade Flange bolt Flange washer a SE2 SE3 SE4 Mounting of Cutter BladeFitting Dust Hose and Dust BAG Dust hose Metal band Dust bag Tying CordFuel HOW to MIX Fuel 14  Recommended Mixing Ratio Gasoline 50OILFor Your Engine LIFE, Avoid Fueling the UnitOP1 OP2 Starting Engine OperationClose  16 Safety lock Start setting button Throttle lever OP3 OP4 OP5Decomp valve OP6 SwitchStopping Engine OFFFor AN Efficient Cutting Operation OP7 OP8 Cutting OperationFront guide Horizontal Cutting Vertical CuttingAIR Cleaner MaintenanceAir cleaner cover Top plate Felt filter MA1MA3 MA2Spark Plug NGK BPM8YMA4 MA5 Cooling AIR Passage Blade Drive Belt 22  Disassembling Procedure MA6 MA7 MA8 MA9Belt Exchange  24  Assembling ProcedureIdler pulley Belt adjustment plate Bolt Tighten Slacken FAN Drive Belt Belt Tension Adjustment and ExchangeMA14  25 When adjusting, take the following steps Engine Adjustment MA15MA15  26  27   28  Starter Rope ExchangeNotch MA19 MA20 MA21 30   31  StorageTroubleshooting guide Check Probable Causes Action 32   33  Parts list 34  Cutter Unit HC510DV S/N 200101 and up 35   36  Power Unit 1 HC510DV S/N 200101 and up 37   38  Power Unit 2 HC510DV S/N 200101 and up 39   40  Carburetor HC510DV S/N 200101 and up 41  Accessories & Tool SET HC510DV S/N 200101 and upManufacturer’s warranty coverage Limited Warranty RedMax Garantie limitée