8. Operation
OP7
OP8
■CUTTING OPERATION
•For cutting, hold the machine in your body centre and lead the dust hose through both legs. Lightly bend the knees and keep a stable posture.
•When applying the cutter blade to a work, start with low speed to form a guide notch, and then cut with full throttle.
IMPORTANT
Do not forcedly press the cutter blade during cutting. It may end up with quick wear of blade or troubles on a drive mechanism.
■FOR AN EFFICIENT CUTTING OPERATION
•In case the front guide tip is not contacting a work, capture of dusts becomes insufficient and its dust collection performance is spoiled.
•A front guide under the blade cover can slide. For cutting operation, press the front guide tip onto a work.
•Dusts are sucked from the front guide tip and collected in a dust bag after passing through inside of the blade cover, a dust collection fan and the dust hose.
•The dust collection performance is dependable to cutting direction. Before stating the operation, refer (OP8) and decide a cutting direction so that dusts are efficiently collected thorough the front guide
•Dust collection performance is spoiled if the dust bag is full with dusts or clogged with water.
•At least once in every day, remove the dusts in the dust bag by opening the fastener. In case the bag is wet with water, dry it thoroughly for next use.
(1) Front guide
(A)Horizontal Cutting
Move cutter back from forward.
(B)Vertical Cutting
Move cutter downward.