Graco 332458B important safety instructions Personal Protective Equipment, Equipment Misuse Hazard

Page 7

Warnings

WARNING

PERSONAL PROTECTIVE EQUIPMENT

Wear appropriate protective equipment when in the work area to help prevent serious injury, including eye injury, hearing loss, inhalation of toxic fumes, and burns. This protective equipment includes but is not limited to:

•Protective eyewear, and hearing protection.

•Respirators, protective clothing, and gloves as recommended by the fluid and solvent manufacturer.

EQUIPMENT MISUSE HAZARD

Misuse can cause death or serious injury.

•Do not operate the unit when fatigued or under the influence of drugs or alcohol.

•Do not exceed the maximum working pressure or temperature rating of the lowest rated system component. See Technical Data in all equipment manuals.

•Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data in all equipment manuals. Read fluid and solvent manufacturer’s warnings. For complete information about your material, request MSDS from distributor or retailer.

•Do not leave the work area while equipment is energized or under pressure.

•Turn off all equipment and follow the Pressure Relief Procedure when equipment is not in use.

•Check equipment daily. Repair or replace worn or damaged parts immediately with genuine manufacturer’s replacement parts only.

•Do not alter or modify equipment. Alterations or modifications may void agency approvals and create safety hazards.

•Make sure all equipment is rated and approved for the environment in which you are using it.

•Use equipment only for its intended purpose. Call your distributor for information.

•Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.

•Do not kink or over bend hoses or use hoses to pull equipment.

•Keep children and animals away from work area.

•Comply with all applicable safety regulations.

332458B

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents ProMix PD2K Proportioner for Automatic Spray Applications Important Safety InstructionsRelated Manuals Contents0359 ModelsModel AC2000 High Pressure Identification Label Electric Shock Hazard Fire and Explosion HazardToxic Fluid or Fumes Intrinsic SafetySkin Injection Hazard Moving Parts HazardEquipment Misuse Hazard Personal Protective EquipmentChanging Materials Important Isocyanate ISO InformationIsocyanate Conditions Moisture Sensitivity of IsocyanatesLength ft m System Control Drawing 16P577Hazardous Classified Location NON-HAZARDOUS Location onlySelect a Base Model Configure Your SystemComponent Description Hazardous Classified Location NON-HAZARDOUS Location only Typical InstallationViscosity Ratio Resin a Catalyst B Select HosesHose Selection Tool Recommended Hose Sizes internal diameter for a and BSpray Guns Select a Spray GunApplication Gun Model Gun Manual No Low Pressure Circulating Kits Select Non- is Color and Catalyst Change KitsKit Part No Kit Description Color + Solvent Valves Select is Remote Color Change KitsSelect Pump Expansion Kits Mounting the PD2K Base Unit General InformationAdvanced Display Module Connection Ports Install the Display ModuleKey Connection Description Air SupplyAir Requirements Air ConnectionsFluid Requirements Fluid SupplyColor Change Connections Single Color ConnectionsCatalyst 35 cc pumps Repeat for the lower throat cartridge TSL Cup KitLight Tower Accessory Solvent Meter AccessoryElectrical Connections Wire KeyElectrical Supply Electrical RequirementsGrounding Key Hazardous Location NON-HAZARDOUS LocationSolvent Reservoir or Purge Station Object Being SprayedCheck Resistance Power Module Electrical SchematicsEfcm Efcm J8 J9 J15 J16 J14 J10 J15 J16 Electrical Schematic, Sheet 3, Hazardous Location Optional Cables Modules Dimensions Positive Displacement Metric Proportioner Technical DataGraco Information Graco Standard Warranty
Top Page Image Contents