Graco 332458B Electrical Supply, Electrical Requirements, Electrical Connections, Wire Key

Page 25

Electrical Supply

Improper wiring may cause electric shock or other serious injury if work is not performed properly. All electrical wiring must be completed by a qualiﬁed electrician and comply with all local codes and regulations.

Electrical Requirements

Enclose all cables routed in the spray booth and high trafﬁc areas in conduit to prevent damage from paint, solvent, and trafﬁc.

The unit operates with 90-250 VAC, 50/60 Hz input power, with a maximum of 7 A current draw. The power supply circuit must be protected with a 15 A maximum circuit breaker.

•A power supply cord compatible to your local power conﬁguration is not included. Wire gauge size must be 8-14 AWG.

•The input power access port is 22.4 mm (0.88 in.) in diameter. A strain relief is provided which accepts a cord diameter of 0.157–0.354 in. (4–9 mm). If another cord size is used, a user-supplied, appropriate size strain relief must be installed.

Electrical Supply

Electrical Connections

See Electrical Schematics, page 29.

1.Verify that electrical power at the main panel is shut off. Open the Control Box cover.

2.Thread the electrical cord wires through the strain relief (S).

3.Connect the wires (L, N, G) securely to the corresponding terminals of the terminal block (T), as shown.

4.Tighten the strain relief nut securely.

5.Close the Control Box. Restore power.

6.Follow instructions in Grounding, page 26.

Wire Key
	Wire		Description
	Wire		Description
	L		Line Power
	N		Neutral
	G		Ground

Figure 14 Control Box Electrical Connection

332458B

25

Image 25

Contents ProMix PD2K Proportioner for Automatic Spray Applications Important Safety InstructionsRelated Manuals Contents0359 ModelsModel AC2000 High Pressure Identiﬁcation Label Electric Shock Hazard Fire and Explosion HazardSkin Injection Hazard Intrinsic SafetyMoving Parts Hazard Toxic Fluid or FumesEquipment Misuse Hazard Personal Protective EquipmentIsocyanate Conditions Important Isocyanate ISO InformationMoisture Sensitivity of Isocyanates Changing MaterialsLength ft m System Control Drawing 16P577Hazardous Classified Location NON-HAZARDOUS Location onlySelect a Base Model Conﬁgure Your SystemComponent Description Hazardous Classified Location NON-HAZARDOUS Location only Typical InstallationHose Selection Tool Select HosesRecommended Hose Sizes internal diameter for a and B Viscosity Ratio Resin a Catalyst BSpray Guns Select a Spray GunApplication Gun Model Gun Manual No Low Pressure Circulating Kits Select Non- is Color and Catalyst Change KitsKit Part No Kit Description Color + Solvent Valves Select is Remote Color Change KitsSelect Pump Expansion Kits Mounting the PD2K Base Unit General InformationAdvanced Display Module Connection Ports Install the Display ModuleAir Requirements Air SupplyAir Connections Key Connection DescriptionFluid Requirements Fluid SupplyColor Change Connections Single Color ConnectionsCatalyst 35 cc pumps Repeat for the lower throat cartridge TSL Cup KitLight Tower Accessory Solvent Meter AccessoryElectrical Supply Wire KeyElectrical Requirements Electrical ConnectionsGrounding Key Hazardous Location NON-HAZARDOUS LocationSolvent Reservoir or Purge Station Object Being SprayedCheck Resistance Power Module Electrical SchematicsEfcm Efcm J8 J9 J15 J16 J14 J10 J15 J16 Electrical Schematic, Sheet 3, Hazardous Location Optional Cables Modules Dimensions Positive Displacement Metric Proportioner Technical DataGraco Information Graco Standard Warranty