Graco 247936, 247937 important safety instructions Select a Fluid Nozzle and Air Cap, Orifice Size

Select a Fluid Nozzle and Air Cap

The gun is supplied with Part No. 197266 Nozzle and 24A276 Air Cap. If you require a different size, refer to Table 1 and Table 2 , and instruction manual 309419, or consult with your Graco distributor. See Replace Air Cap/Nozzle on page 28.

A wide pattern kit (P/N 24A431) is included with the gun and if installed, will provide more fan air for wider spray patterns. (If pattern becomes split, use the fan air valve to reduce the amount of fan air.)

To reduce the risk of an injury, follow the Pressure Relief procedure on page 19 before removing or installing a fluid nozzle and/or air cap.

NOTE: Due to the larger needle diameter, use a nozzle one size larger than you would use with a standard Pro Xs gun (i.e., 1.5 mm = 1.2 mm flow area).

	Table 1: Fluid Nozzles
Part No.		Orifice Size
197265		1.2 mm (.047 in.)
197266		1.5 mm (.055 in.)
197267		1.8 mm (.070 in.)
249922*		1.2 mm (.047 in.)
249923*		1.5 mm (.055 in.)
249924*		1.8 mm (.070 in.)

* Glass-reinforced acetal construction.

Installation

Table 2: Air Caps

	Pattern Shape	Recommended Fluids and
Part No.	and Length in.
		Production Rates
	(mm)
24A438	Round end;	Light to medium viscosity.
	15-17 (381-432)	Up to 15 oz/min (450 cc/min)
	Round end;	Medium to high viscosity and
24A279		high solids.
	14-16 (356-406)
		Up to 15 oz/min (450 cc/min)
24A276*	Tapered end;	Light to medium viscosity.
	17-19 (432-483)	Up to 15 oz/min (450 cc/min)
24A274	Tapered end;	Light to medium viscosity.
	12-14 (305-356)	Up to 15 oz/min (450 cc/min)
		Medium to high viscosity and
24A439	Round end;	high solids.
	11-13 (279-330)	Up to 15 oz/min (450 cc/min)
		For use with 2.0 mm nozzle.
		Light to medium viscosity and
24A275	Tapered end;	high solids.
	14-16 (356-406)	Aerospace coatings.
		Up to 25 oz/min (750 cc/min).

*Also available in the following colors: 24A376 - gray

24A277 - red

24A278 - green

312900G 13