Graco Inc 1095 Premium Hi-Boy, 695 Premium Hi-Boy, 795 Premium Hi-Boy Grease shaft Install swivel

Page 38

Hose Reel

Installation

1. Grease shaft.

6. Install swivel.

ti13537a

2. Replace swivel shaft if it was removed.

ti13544a

3.Replace rigid fluid tube to swivel shaft if it was removed.

ti13541a

4.Make sure two washers and wave spring are on hub before hose reel is installed.

ti13545a

5.Install hose reel onto frame. Place C-clamp on reel and frame to allow snap ring to fit into place. Install snap ring.

ti13536a

ti13543a

7. Install E-clip and swivel cap.

ti13538a

8.Install hose to swivel. Make sure to route hose through side arm of hose reel.

ti13539a

9.Turn hose reel clockwise to wrap up hose. Make sure hose is routed through hose guide.

ti13504a

38

3A0157A

Image 38

Contents Electric Airless Sprayers MarkModels Ultra MAX lIlTable of Contents Grounding Instructions GroundingFire and Explosion Hazard Skin Injection HazardPressurized Aluminum Parts Hazard Equipment Misuse HazardElectric Shock Hazard Moving Parts HazardComponent Identification Pressure Relief Procedure Pails Power RequirementsGrounding Extension CordMechanical/Fluid Flow TroubleshootingWhat to Check What to do Type of Problem Follow Pressure Relief Procedure on What to Check What to do Type of Problem Type of Problem What to Check HOW to Check ElectricalCheck to see if transducer and control board Step Check Motor Thermal Switch Unplug thermal Is not correct, replace motor Sprayer Will Not Shut Off YESSprayer Will Not Run Step Removal Installation VAC and 110 VAC Motor Control Board33 D 115 VAC Filter Board RemovalPressure Adjust Potentiometer Pressure Control Transducer Install control box 61 and control panel 68 with four screws 3A0157A Assembly Drive and Bearing Housing ReplacementDisassembly Drive and Bearing Housing Replacement Removal Motor ReplacementInstallation Motor Replacement Displacement Pump Replacement for 695/795/Mark Perform Relieve Pressure ProcedureTi7169a Displacement Pump Replacement 1095/1595/Mark Perform Pressure Relief Procedure,Place u-bolt on pump door protrusion Attach drain hose to sprayer Hose Reel Grease shaft Install swivel Reed Switch Replacement Removal InstallationWiring Diagram 120V Models120V Models with 15/20 Amp Switch 240V Models 3A0157A Graco Standard Warranty For Graco Canada Customers