Reed Switch Replacement
Reed Switch Replacement
Removal | Installation |
1. Remove four screws and remove display cover.
ti13568a
1.Apply thread sealant to end of reed switch. Hand tighten reed switch until it is tight against control panel.
ti13574a
2.Add thread sealant and tighten jam nut against threaded bus.
2. Remove two screws and remove control panel.
ti13576a
3. Connect reed switch to control board.
ti13571a
3. Unplug reed switch from control board.
ti13572a
4. Replace control panel and tighten two screws.
ti13572a
4. Unscrew reed switch from control panel.
ti13571a
5. Replace display cover and tighten four screws.
ti13573a
ti13568a
3A0157A | 39 |