Grizzly G1005Z owner manual Test Run, To test run the machine

Page 17

5.Thread the handwheel handles into the handwheels and tighten using a 5mm hex wrench.

6.Thread the remaining handwheel handle into the headstock adjustment handle.

Test Run

Once the assembly is complete, test run your machine to make sure it runs properly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review the Troubleshooting on Page 27.

If you still cannot remedy a problem, contact our Tech Support at (570) 546-9663 for assistance.

G1005Z Mill/Drill

To test run the machine:

1.Make sure you have read the safety instruc- tions at the beginning of the manual and that the machine is setup properly.

2.Make sure all tools and objects used during set up are cleared away from the machine.

3.Ensure the machine is switched OFF.

4.Connect the machine to the power source.

5.Turn the machine ON.

6.Listen to and watch for abnormal noises or actions. The machine should run smoothly with little or no vibration or rubbing noises.

—Strange or unusual noises should be inves- tigated and corrected before operating the machine further. Always disconnect the machine from power when investigating or correcting potential problems.

-15-

Image 17

Contents Model G1005Z MILL/DRILL Page Table of Contents Contact Info IntroductionForeword Machine Data Sheet Lead Screw Info Identification Safety G1005Z Mill/Drill Additional Safety for Mill/Drills 110/220V Operation Circuit RequirementsAmperage Draw Circuit RequirementsExtension Cords Grounding110V Operation 220V OperationSet Up Safety SET UPItems Needed for Set UnpackingOther Components and Hardware InventoryMain Components Figure Qty Site Considerations Clean UpWorkbench Load Operational ClearancesTo assemble the Model G1005Z MountingAssemblyTo test run the machine Test RunInstalling/Removing Tooling Operation SafetyUsing Clean Tapers To install tooling on included mill arborTo install end mill tooling To install an arborTo install the drill chuck To remove an arborTo remove a drill bit To install a drill bitLongitudinal Feed Cross FeedMicro-Downfeed Handwheel Graduated DialsBacklash To correct for backlashDepth Stop Quill LockChoosing Milling Speeds Using the Drill Bit Speed ChartChoosing Drilling Speeds Lubrication SuggestionsDrill bit speed chart To change speeds Changing SpeedsDrilling Guidelines H1300 H1298 G7984 H2347 H0736 AccessoriesH2689-R8 Quick Change Collet Set Cleaning MaintenanceSchedule Unpainted Cast IronMotor & Electrical ServiceTroubleshooting Operation Symptom Possible Cause Possible SolutionSymptom Possible Cause Possible Solution To calibrate the depth stop Depth Stop Feed Shaft Spring CalibrationPage G1005Z Junction Box G1005Z Mill/Drill Electrical ComponentsWiring Diagram G1005Z Description G1005Z Main Assembly Parts ListG1005Z Table Breakdown G1005Z Table and Labels Parts List Warranty and Returns Page Page