Grizzly owner manual MountingAssembly, To assemble the Model G1005Z

Page 16

MountingAssembly

The Model G1005Z must be mounted to a workbench or stand before it can be safely used.

If mounting to a stand, follow the mounting instructions included with the stand. We recommend using the Grizzly Model G5943 stand, which can be found in SECTION 5: ACCESSORIES on Page 25.

For workbenches, the strongest mounting option is a "through mount" where holes are drilled all the way through the workbench, and hex bolts, washers, and hex nuts are used to secure the mill/drill to the workbench.

��

��

��

��

��

��

��

Figure 5. Example of a through mount setup.

Another option for mounting is a "direct mount" where the machine is simply secured to the work- bench with a lag screw.

��

��

��

��

Figure 6. Example of a direct mount setup. -14-

The Model G1005Z must be completely assembled before it can be safely used.

To assemble the Model G1005Z:

1.Thread the downfeed handle knobs onto the downfeed handles.

2.Thread the downfeed handles into the pinion hub, as shown in Figure 7.

Figure 7. Downfeed handles installed.

3.Remove the caps from the handwheel hubs.

4.Slide the handwheels onto the handwheel shafts as shown in Figure 8, and tighten the handwheel setscrews.

Figure 8. Table handwheels installed.

G1005Z Mill/Drill

Image 16

Contents Model G1005Z MILL/DRILL Page Table of Contents Foreword IntroductionContact Info Machine Data Sheet Lead Screw Info Identification Safety G1005Z Mill/Drill Additional Safety for Mill/Drills Circuit Requirements 110/220V OperationAmperage Draw Circuit RequirementsGrounding Extension Cords110V Operation 220V OperationSET UP Set Up SafetyItems Needed for Set UnpackingMain Components Figure Qty InventoryOther Components and Hardware Clean Up Site ConsiderationsWorkbench Load Operational ClearancesMountingAssembly To assemble the Model G1005ZTest Run To test run the machineOperation Safety Installing/Removing ToolingUsing Clean Tapers To install tooling on included mill arborTo install an arbor To install end mill toolingTo install the drill chuck To remove an arborTo install a drill bit To remove a drill bitLongitudinal Feed Cross FeedGraduated Dials Micro-Downfeed HandwheelBacklash To correct for backlashQuill Lock Depth StopUsing the Drill Bit Speed Chart Choosing Milling SpeedsChoosing Drilling Speeds Lubrication SuggestionsDrill bit speed chart Changing Speeds To change speedsDrilling Guidelines H2689-R8 Quick Change Collet Set AccessoriesH1300 H1298 G7984 H2347 H0736 Maintenance CleaningSchedule Unpainted Cast IronTroubleshooting ServiceMotor & Electrical Symptom Possible Cause Possible Solution OperationSymptom Possible Cause Possible Solution Depth Stop Feed Shaft Spring Calibration To calibrate the depth stopPage Electrical Components G1005Z Junction Box G1005Z Mill/DrillWiring Diagram G1005Z G1005Z Main Assembly Parts List DescriptionG1005Z Table Breakdown G1005Z Table and Labels Parts List Warranty and Returns Page Page