Operating Instructions
TIMER Operation
|
| MODE FAN |
| SWING |
|
| TEMP | HEALTH | |
|
| CLOCK |
| SET |
| SET | 2TIMER |
| SLEEP 4 |
|
|
| 3 | |
ON |
| FILTER RESET | RESET | |
|
|
|
| |
AM | AM |
|
|
|
ON/OFF 
1
T E M P
ON
OFF
SWINGFAN
1
MODE SLEEP
HEALTH FRESH
CLOCKSET
2
TIMER4
3
Set Clock correctly before starting Timer operation.
RESET | LIGHT LOCK |
You can let unit start or stop automatically at following time: Before you wake up in the morning, or get back from outside or after you fall asleep at night.
TIMER ON/OFF
(1)After unit start, select your desired operation mode.
Operation mode will be displayed on LCD. Power indicator lights up.
(2)TIMER mode selection
Press TIMER button to change TIMER mode. Every time the button is pressed, display changes as follows:
(3)Timer setting
Press TIME | button. |
Every time the button is pressed, time increases 10min. If button is kept depressed, time will change quickly. 
Every time the button is pressed, time decreases 10min. If button is kept depressed, time will change quickly. Time will be shown on LCD. It can be adjusted within 24hours.
ON | OFF | ON | blank | |
OFF | ||||
|
|
|
Select your desired TIMER mode (ON or OFF)
To cancel TIMER mode
(4)Confirming your setting
After setting correct time, press SET button to confirm "ON" or "OFF" stops flashing.
Time displayed: Unit starts or stops at x hour x min (ON or OFF).
Timer mode indicator lights up.
Just press TIMER button several times until TIMER mode disappears.
According to the seting timing open, close sequence, can realize first open then colse the unit or first close then open the unit.
Hints: 
Wire controller possesses memory function, when use TIMER mode next time, just press SET button after mode selecting if timer setting is the same as previous one.
Wire remote controller or remote controller can memorize each working condition. Next time open the unit, only need to press the ON/OFF key, the AC can work according to last time working condition.(Timing, Sleeping and Swing mode not included.)
From Timing close to timing open, can setting sleep mode.
Please close health function first before setting Timer, then you can do the TIMER ON operation.Please do not use the health function when in TIMER ON state.
1 3