
D
Remote LCD display contents and key name and each key function introduction
11
12
13
4
6
21
201.ON/OFF button
|
| B | A | Used to turn on/off unit | |
|
| 2.Temperature Setting button | |||
|
|
| 15 | ||
AUTO | ion |
| 16 | Used to set temperature, | |
|
|
| 17 | temperature range: 16 C~30 C | |
|
| OFF | 18 | 3.Health | |
|
| H | 19 | Used to control the | |
|
| T E M P | 2 | generating oxygen function | |
|
| ON |
| and negative | |
|
| OFF | 7 | ||
HEALTH |
|
| |||
|
| FAN | 4.Operation mode button | ||
MODE | SWING | ||||
|
| 8 | Used to set working mode: |
| 9 | Cooling, Dehumidifying, |
TIMER | Heating | |
|
| 5.Timer button |
|
| Used to set the |
RESETCODE | LOCK | mode of timer |
| 10 | 6.Reset button |
|
|
When the remote controller appears abnormal condition, use a
7.Fan speed button
Used to set fan speed
8.Swing button
Used to set Auto Swing or
Fixed air sending direction
9.Time Adjusting button 10.Lock button
Press on time lock all the key sand press another time concel the lock.
11.Working mode display
12.Fan speed display
Used to display the fan speed. After setting "AUTO" function,air speed can auto change according to the temp. difference between the room temp. and setting temp.
13.Health running display
Used to display healthy running.
14.Timer ON/OFF display
Display Timing mode. "Blank" No Timing
"OFF " Timing off
"ON " Timing on
15.Signal display
Sending out signal to the remote receiver.
16.Temperature display Display the setting temp. value.
17.Lock display
Display the key have been locked.
18.Super/Soft operation display 19.Timing time display
Display timing open time or timing close time
20.Signal launch head
Use to send signal to the indoor unit receive window.
21.Code
Select remote control receive
Make sure that the remote controller is used within 7 meters from receiver window of the wire controller and there are no obstructions in between.
The remote controller or wire controller should be handled with care.
When operating the remote controller in an area where electronically controlled lights are installed or wireless handsets are used, move closer to the indoor unit as the function of the remote controller might be affected by signals from this equipment.
| R |
Note: |
|
1.After change the battery, working condition resume as follows: |
|
Working mode:cooling | Temp. 26 C |
Timming mode: normal | Air speed: Auto |
2.The units used in this manual no 8 18 functions. The health key can only control the negative generator.
7