MRV Communications AE09~212FCAKA, AE212FCAKA, AE092FCAKA, AE072FCAKA, AE142FCAKA Clock set

Page 9

D

Clock set

When unit is started for the first time, clock should be adjusted as follows:

Press CLOCK button, "AM"or "PM" flashes.

Press or to set correct time. Each press will increase or decrease 1min. If the button is kept depressed, time will change quickly.

After time setting is confirmed, press SET, "AM "and "PM" stop flashing, while clock

starts working.

Battery loading

Batteries are fitted as follows:

 

*

*

*

 

*

Remove the battery compartment lid

 

Slightly press and disengage the battery compartment lid marked with ì

î and then hold

the remote controller by the upper section and then remove the battery compartment lid by pressing in the direction of the arrow as shown in the figure above.

Loading the battery

Ensure that batteries are correctly placed in the compartment as required for positive and negative terminals.

Replacing the battery compartment lid

The battery compartment lid is reinstalled in the reverse sequence.

Display review

Press the button to see if batteries are properly fitted. If no display appears, refit the batteries.

Caution:

If the remote controller does not operate as designed after fitting new batteries of the same type, press the Reset button (marked ) with a pointed article.

Note:

It is recommended that the batteries be removed from the compartment if the remote controller is not used for an extended period.

The remote controller is programmed for automatic test of operation mode after the batteries are replaced. When the test is conducted, all icons will appear on the screen and then disappear if the batteries are properly fitted.

When the display become weak, this display no power in the battery, please change the battery.

 

5

2

4

 

3

 

1

R

1 .Emergency switch

2 .Power lamp

After open the unit, this lamp bright when the unite enter health running, the lamp change from orange to blue lamp.

3 .Timing lamp

When the unit been setting Timing running, this lamp bright.

4 .Running lamp

When the compressor working, this lamp bright. 5 .Indoor temp. sensor

Test the room temperature.

8

Image 9
Contents Ceilingconcealedtypeairconditionerindoorunit ContentsPage DB C AE072FCAKA AE242FCAKA Fig1 Calibration of clock Remote controller Operation of remote controller 20 1.ON/OFF button Clock set Important Points of Safety Smell etc. occurs, stop running Important Points of Safety Recommendations Operating Instructions Timer OperationTimer ON-OFF Sleep Function Health Function Following cases are not troubles Trouble ShootingSystem couldnt start Is power on/off switched on? When Fault Occurs Poor cooling or heatingPoor cooling Information about application Installation Precautions Electrical requirements Installing toolsFigure showing installation dimensions unitmm Installation ProcedureInstallation of indoor unit Transitive air duct New concrete slab Remove upper cover of wire controller Installation of remote controllerInstallation of receive display Requirements Drain pipePipe expansion dimensions as follows Refrigerant pipingPipe cutting and expanding Open all valves Ring terminal connection method Electric wiringField setting Malfunction Indoor unit malfunction display codeOutdoor unit malfunction display code Outdoor unit malfunction Indoor unit malfunction