7To specify the location of the file that you want to import into the Lmhosts file, select Import LMHOSTS and then select the file in the Open dialog box.
8Enable or disable NetBIOS over TCP/IP.
If using Microsoft Windows Server 2008 Core Version, use the netsh interface command to configure the iSCSI ports on the host server.
Linux Host Setup
To set up a Linux host network, you must configure the IP address and netmask of each iSCSI port connected to the storage array. The specific steps depend on whether you are configuring TCP/IP using DHCP or configuring TCP/IP using a static IP address.
NOTE: The server IP addresses must be configured for network communication to the same IP subnet as the storage array management and iSCSI ports.
Using DHCP
If you are using DHCP (root users only):
1Edit the /etc/sysconfig/network file:
NETWORKING=yes HOSTNAME=mymachine.mycompany.com
2Edit the configuration file for the connection you want to configure, either
BOOTPROTO=dhcp
Also, verify that an IP address and netmask are not defined.
3Restart network services using the following command:
/etc/init.d/network restart
Using A Static IP Address
If you are using a static IP address (root users only)
1Edit the /etc/sysconfig/network file as follows:
42
Post Installation Tasks