Dell MD3220, MD3200 manual Connect to the Target Storage Array From the Host Server

7Select one:

•If you are not using CHAP authentication, select No Authentication. Go to step 8.

or

•If you are using CHAP authentication, enter the CHAP user name and password. To enable Mutual CHAP, select and enter the Mutual CHAP user name and password.

8Repeat step 7 for each target until at least one connection is logged in for each controller.

9Go to Connected Targets.

10Verify that the targets are connected and displays a status of true.

Step 7: Connect to the Target Storage Array From the Host Server

If you are using Windows Server 2008 GUI:

1Click Start→ Programs→ Microsoft iSCSI Initiator or click Start→ All Programs→ Administrative Tools→ iSCSI Initiator.

2Click the Targets tab.

If previous target discovery was successful, the iqn of the storage array should be displayed under Targets.

3Click Log On.

4Select Automatically restore this connection when the system boots.

5Select Enable multi-path.

6Click Advanced and configure the following settings under the General tab:

•Local Adapter—Must be set to Microsoft iSCSI Initiator.

•Source IP—The source IP address of the host server you want to connect from.

•Target Portal—Select the iSCSI port on the storage array controller that you want to connect to.

Appendix—Manual Configuration of iSCSI

69