Step 3. Installing a Disk Enclosure
Before you can install the disk enclosure, you must first remove the enclosure slide rails from the rack, then you need to attach the enclosure slide rails to the disk enclosure(s). Instructions for this procedure are provided below.
Removing Enclosure Slide Rails from the Rack
The slide rails are delivered already mounted in the flange mounts on the rack. You must remove the slide rails from the rack and attach them to the disk enclosure.
Open the side doors, as this is the easiest way to access enclosure slide rails, which are mounted in the stationary flange mounts. See Figure 9.
1.Pull the left slide rail forward in the flange mount until the lock button locks into place.
2.Press in the button on the back of the slide rail (1) to unlock it from the stationary flange mount, and slide it out until it stops.
Stationary Flange Mount
1
Locking Button attached to Enclosure Slide Rail
Left side | 2700 |
| |
of Rack |
|
Figure 9. Releasing the Lock Button from the Lock Button Mating Hole
16FibreSTORE RAID System: Rack Installation Guide