3.Using caution, push the tab (2) and pull the slide rail completely out of the stationary flange mount (3), as shown in Figure 10.
Left Side of Rack lookng into the front
2
Stationary Flange Mount
Enclosure Slide Rail
3
2702
Figure 10. Removing Enclosure Slide Rail from Stationary Flange Mount
WARNING Be very careful, not to pinch your fingers when completing this step.
4.Repeat steps 1 - 3 for the right side.
5.Install one slide rail on each side of the disk enclosure, as shown in Figure 11. Position the lock button assembly to the rear. Secure the slide rails, using five 3/8"
Enclosure | Front Lock |
| |
Slide Rail |
| ||
Button | Rear | ||
| |||
|
|
| Front | 3/8” |
2430 | 5 per side | |
|
|
Figure 11. Disk Enclosure Rack Mount Components
Chapter 2: Installing in a Ciprico Rack | 17 |