Ciprico 21021625 B manual Disk Enclosure Rack Mount Components

Page 28

5.Install one enclosure slide rail on each side of the disk enclosure, as shown in Figure 18. Position the lock button assembly close to the rear of the disk enclosure. Use five 3/8" #10-32 pan head screws to secure each enclosure slide rail to the disk enclosure.

Enclosure

Front Lock

 

Slide Rail

 

Button

Rear

 

 

 

 

Front

3/8” #10-32 Pan Head Screw -

2430

5 per side

 

 

Figure 18. Disk Enclosure Rack Mount Components

28FibreSTORE RAID System: Rack Installation Guide

Page 27 Page 29
Image 28
Page 27 Page 29
Contents
Table of Contents RAID SystemCustomer Service Customer SupportChapter Introduction Back View of FibreSTORE RAID Rack Front View of FibreSTORE RAID Rack Supported Rack Configurations Configuration for One RAID System AAMK36AConfiguration for Two RAID Systems AAMK36A2 Configuration for Three RAID Systems AAMK36A3Configuration for Four RAID Systems AAMK36A4 AAMK36A4 Rack ConfigurationSafety Considerations Preparing the Installation Site WeightInstalling in a Ciprico Rack Overview Preparing the Rack Installing a Cache Retention Unit CRU Installing a CRUCRU Screwed into the Rack Installing a Disk Enclosure Removing Enclosure Slide Rails from the RackRemoving Enclosure Slide Rail from Stationary Flange Mount Installing a Disk Enclosure in the Rack Lifting Disk Enclosure and Aligning Enclosure slidesAdjusting Lock Buttons on Slide Installing a Controller Enclosure Attaching Controller Enclosure Support AnglesInstalling Support Angles Installing Mounting Brackets Putting on the Filler Panels Putting on Filler PanelsFibreSTORE RAID System Rack Installation Guide Chapter Installing in a Generic Rack Installing the Cache Retention Unit CRU Installing Slide Rails on a Disk Enclosure Generic Disk Enclosure Installation Kit SlidesDisk Enclosure Rack Mount Components Installing the Stationary Flange Mount in the Rack Stationary Flange Mount Slide AssemblyInstalling Disk Enclosures into a Rack Aligning Disk Enclosure SlidesReleasing Lock Buttons on Enclosure Slide Releasing Disk Enclosure Front Lock Button Installing the Controller Enclosure Attaching Mounting and Support BracketsInstalling Controller Enclosure Support Brackets Installing the Controller Enclosure FCC Radio Frequency Interference Statement
Related manuals
Manual 36 pages 37.46 Kb