Ciprico 21021625 B manual Installing Support Angles

1.Attach the rear bracket to the support angle with four 1/2" #10-32 screws. (Figure 14 shows a right support angle.)

Front

Channel

Mount

Rear Bracket

Back

Channel

Mount

1/2” #10-32 Screws -

2 per side

1/2” #10-32	Support Angle
Screws -
	1/2” #10-32
2 per side
	Screws -
	4 per side	Cage Nuts -
2288		2 per side

Figure 14. Installing Support Angles

2.Install the front end of a support angle into matching holes at the front of the rack with two 1/2" #10-32 screws.

3.Insert two cage nuts onto the back channel mount over the holes you aligned.

4.Align the rear (bracketed) end of the support angle with the holes in the back channel mount.

5.Fasten the rear bracket attached to the back of the support angle with two 1/2" #10-32 screws through the cage nuts.

6.Repeat steps 1 - 5 to attach the other support angle to the rack. The left support angle should mirror the right and be at the same height.

Chapter 2: Installing in a Ciprico Rack 21