Ciprico 21021625 B manual Installing Mounting Brackets

Page 22

Installing Mounting Brackets

A controller enclosure is shipped without the mounting brackets installed; you must install them before you install the controller enclosure in a rack. The Ciprico-provided install kit contains the parts you need to attach the mounting brackets to the controller enclosure and the enclosure to the rack.

Install the controller enclosure from the front of the rack.

1.Attach the brackets on both right and left sides of the controller enclosure with three counter-sunk Phillips head 1/4" #6-32 screws, as shown in Figure 15.

2.Align the slots on the mounting brackets of the controller enclosure with the cage nuts as shown in Figure 15.

Cage Nuts

Controller

 

Enclosure

Support

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Controller

Angle

 

Controller

 

2

 

 

1

 

 

 

 

 

 

 

 

 

 

 

#10-32 Screws - 2 per side

#6-32Screws -

Controller Enclosure

2362

3 per side

Mounting Brackets

 

 

 

Figure 15. Installing the Controller Enclosure in a Ciprico (Hoffman) Rack

3.Rest the controller enclosure on the support angles and slide the enclosure back and into place.

4.Secure the controller enclosure to the rack with four 1/2" #10-32 (2 per side) screws in the cage nuts as shown in Figure 15.

22FibreSTORE RAID System: Rack Installation Guide

Image 22
Contents Table of Contents RAID SystemCustomer Service Customer SupportChapter Introduction Back View of FibreSTORE RAID Rack Front View of FibreSTORE RAID Rack Supported Rack Configurations Configuration for One RAID System AAMK36AConfiguration for Two RAID Systems AAMK36A2 Configuration for Three RAID Systems AAMK36A3Configuration for Four RAID Systems AAMK36A4 AAMK36A4 Rack ConfigurationSafety Considerations Preparing the Installation Site WeightInstalling in a Ciprico Rack Overview Preparing the Rack Installing a Cache Retention Unit CRU Installing a CRUCRU Screwed into the Rack Installing a Disk Enclosure Removing Enclosure Slide Rails from the RackRemoving Enclosure Slide Rail from Stationary Flange Mount Installing a Disk Enclosure in the Rack Lifting Disk Enclosure and Aligning Enclosure slidesAdjusting Lock Buttons on Slide Installing a Controller Enclosure Attaching Controller Enclosure Support AnglesInstalling Support Angles Installing Mounting Brackets Putting on the Filler Panels Putting on Filler PanelsFibreSTORE RAID System Rack Installation Guide Chapter Installing in a Generic Rack Installing the Cache Retention Unit CRU Installing Slide Rails on a Disk Enclosure Generic Disk Enclosure Installation Kit SlidesDisk Enclosure Rack Mount Components Installing the Stationary Flange Mount in the Rack Stationary Flange Mount Slide AssemblyInstalling Disk Enclosures into a Rack Aligning Disk Enclosure SlidesReleasing Lock Buttons on Enclosure Slide Releasing Disk Enclosure Front Lock Button Installing the Controller Enclosure Attaching Mounting and Support BracketsInstalling Controller Enclosure Support Brackets Installing the Controller Enclosure FCC Radio Frequency Interference Statement