Installing the Stationary Flange Mount in the Rack
1.Loosely fasten the left side rack mount bracket (use extension bracket if necessary) to the left side stationary flange mount with two screws and one bar nut*, as shown in Figure 19. Adjust the length of the stationary flange mount/rack mount bracket assembly to fit between the front and back channel mounts. Secure the screws holding the stationary flange mount to the rack mount bracket.
| Back Channel Mount Left Side | 3/8” | ||
Rack Mount Bracket or Extension Bracket | Colored Pan | |||
Head Screws | ||||
|
|
| ||
|
| Brass Colored | Back Channel Mount | |
Front Channel |
| Bar Nuts | Mounting Screws | |
Mount Left Side |
|
|
| |
|
|
| Stationary Flange Mount | |
Front Channel |
|
|
| |
Mount Mounting |
|
| 3/8” | |
Screws |
|
| ||
|
| Colored Pan | ||
|
|
| ||
|
|
| Head Screws | |
|
|
| Back Lock Button | |
3/8” | Intermediate | Mating Hole | ||
Slide Rail |
| |||
Colored Pan |
|
| ||
|
| 2605 | ||
Head Screws |
|
| ||
|
|
| ||
Figure 19. Stationary Flange Mount Slide Assembly
2.Position the intermediate slide rail within the stationary flange mount/rack mount bracket assembly with the back mating hole farthest from the back lock button, and center it within the stationary flange mount/rack mount bracket assembly.
3.Position the stationary flange mount/rack mount bracket assembly on the left side of the rack just beneath the enclosure location above (load rack from top down).
4.Hold the stationary flange mount/rack mount bracket assembly in a between the front and back channel mounts. Secure one bar nut with two screws to hold the stationary flange mount/rack mount bracket assembly in place for the front mounting channel, and secure one bar nut with two screws for the back mounting channel.
5.Repeat steps 1 - 4 on the right side.
*If your generic rack has square holes on the channel mounts, contact the original rack manufacturer or your model shop for installation assistance.
Chapter 3: Installing in a Generic Rack | 29 |