Black & Decker BDPR400 instruction manual Tips for painting with the Rapidrollertm, Apid Ollertm

•	Tips for painting with the RAPIDROLLERTM
	Only use a perforated roller cover. Standard roller covers will not work.
•	Inspect roller cover for lint before painting, if needed wash and dry before using.
• When using the RAPIDROLLERTM for the first application, it will take most of the paint in the RAPIDROLLERTMt ube to saturate the roller cover. A second
•	fill may be needed.
	Keep roller moving while pushing plunger in or squeezing trigger to prevent dripping.
•	Stop pushing plunger in or squeezing trigger if the roller starts to skid, slide or					drip.
• When painting in tight areas partially fill RAPIDROLLERTM or pivot the frame . This reduces its overall length.
•	When leaving RAPIDROLLERTM unattended for a longer period of time, wrap roller in a plastic bag to prevent drying, removing as much air as possible
•	from bag.
	Make sure the type of paint you use can be cleaned with either mineral spirits (for oil-based paints) or a warm water and soap solution (for water
•	soluble paints like latex).
	Use drop cloths to protect your floors and anythin else in the room that you do not want accidentally splattered with paint.
•	When using kickstand, alwayspivot headto st aght positionand releasepressure by pullingplunger outslightly.
1.) Lubricate part (a) and (b) using petroleumTM			jelly provided. Attach	APID		OLLERTM		b	c
	assembled roller (c) onto RAPIDROLLER	frame (d). Make sure roller					d
	assembly snaps into locking clip on outer end cap.					a
					B
2.) Push roller frame (a) over end of handle assembly (d) ensuring O-ring
	(b) is seated inside roller frame. Thread handle assembly collar (c)						c	b
	snugly onto threads of roller frame (a).								d
3.) The spatter shield helps reduce spatter when painting, especially on					C
	ceilings. Position the spatter shield by rotating around roller frame.
	RNOTE:APIDROLLERSpatterTM isshieldrestingis alsoon kickstandhelpful toandpreventis notdrippingin use. Justwhenposition
	spatter shield under roller.

APID OLLERTM

1.) Insert the small end of the fill tube (a) through the hole in the bottom side of the paint can cover (b).

Push in until tight and to the ridge of the fill tube.

2.) Snap paint can cover onto paint can (fig. E). Lubricate top of fill tube stem with a small amount of petroleum jelly included in carton. NOTE: The can cover will not fit on some paint containers. It can be stretched over larger cans or compressed slightly by squeezing to fit smaller cans.

To fill the RAPIDROLLERTM when the can cover does not fit your paint container, omit the can cover and place fill tube directly into container. Hold the fill tube with hand to stabilize as needed.

A fill tube can clip is available as an optional accessory for use with other size containers. See “Accessories”.

For deeper containers like 5 gallon pails, fit a section of ¾ inch I.D. (inner diameter) clear tubing over the ribs of the fill tube to extend it

(fig. E1) and clip to side of pail with fill tube can clip. Cut bottom end of tubing at slight angle. Tubing is available at most hardware stores.

3

	b
E	E1a