Fluke PN 643657 instruction sheet Multimeter with Temperature, Read First Safety Information

Page 1

®

16

Multimeter with Temperature

Instruction Sheet

PRead First: Safety Information

To ensure that the meter is used safely, follow these instructions:

∙Do not use the meter if the meter or test leads appear damaged, or if you suspect that the meter is not operating properly.

∙Disconnect the live test lead before disconnecting the common test lead.

∙When using the probes, keep your fingers behind the finger guards on the probes.

∙Do not use the V∙Check mode to measure voltages in circuits that

could be damaged by this mode’s low input impedance (≅2 kΩ).

∙Turn off power to the circuit under test before cutting, desoldering, or breaking the circuit. Small amounts of current can be dangerous.

∙Do not apply more than 600V rms between a meter terminal and earth ground.

∙Use caution when working with voltages above 60V dc or 30V ac rms. Such voltages pose a shock hazard.

PN 643657 June 1997 Rev.2, 3/98

©1997, 1998 Fluke Corporation. All rights reserved. Printed in U.S.A.

Page 1 Page 2
Image 1
Page 1 Page 2
Contents Read First Safety Information Multimeter with TemperatureBattery Saver SymbolsAutomatic Range Selection Manual Range SelectionResistance and Continuity eR AC and DC Voltage∙Check Disable and re-enable VCheckTemperature If the capacitor requires more Capacitance EMicroamps μA Typical voltage Diode Test GRecords the lowest and highest measurements MIN MAX μFMIN MAX with Elapsed Time μF Continuity Capture Disabling the BeeperReplacement Parts MaintenanceFunction Range Resolution SpecificationsMIN MAX Recording Accuracy and Response Time MIN MAX Recording with Elapsed Time Limited Warranty & Limitation of Liability
Top Page Image Contents