Fluke PN 643657 instruction sheet Disabling the Beeper, Continuity Capture

Page 11

Disabling the Beeper

To disable the beeper for all modes, hold down rfor 2 seconds while turning the meter on.

Continuity Capture™

To set up the meter to capture intermittent shorts and opens, turn the

switch to GR, connect the leads to the circuit; then press M.

ip12i.eps

Captures transitions longer than 250 μs (1/4000th of a second).

Transitions after the first transition cause the meter to beep, but the display does not change.

To reset the display to the current condition, press M.

To exit, press Mfor 2 seconds, or change the measurement mode.

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Read First Safety Information Multimeter with TemperatureManual Range Selection SymbolsBattery Saver Automatic Range SelectionResistance and Continuity eR AC and DC Voltage∙Check Disable and re-enable VCheckTemperature If the capacitor requires more Capacitance EMicroamps μA Typical voltage Diode Test GRecords the lowest and highest measurements MIN MAX μFMIN MAX with Elapsed Time μF Continuity Capture Disabling the BeeperReplacement Parts MaintenanceFunction Range Resolution SpecificationsMIN MAX Recording Accuracy and Response Time MIN MAX Recording with Elapsed Time Limited Warranty & Limitation of Liability
Top Page Image Contents