24.Connect the upper and lower collection drums together with the included metal clamp and the provided hex bolt and nut, as shown in
Figure 30.
Figure 30. Installing metal clamp around
collection drum.
25.Place the collection drum vacuum ring on the bottom of the collection drum (see
Figure 31).
Note: During operation, this ring and the vacuum connection to the cyclone funnel will prevent the collection bag from collapsing.
26.Install the three drum latches, as shown in Figure 32, with the (6) 10-24 x 3⁄8" Phillips head screws and (6) 10-24 hex nuts included in the box with the drum latches.
Use the remaining (6) 10-24 x 3⁄8" Phillips head screws and (6) 10-24 hex nuts to plug the lower latch mounting holes.
Note: To avoid bag snags, face the screw heads inside of the drum with the shanks fac- ing outward.
x 6
Figure 32. Installing the latches onto the
collector drum.
27.Slide the rubber seal over the top lip of the collection drum rim. Pay special attention to the direction of the seal, as shown in the
Figure 33.
Tip: Use an adhesive to keep the seal in place.
Seal
Figure 31. Inserting collection drum vacuum | Figure 33. Installing drum lid seal. |
ring. |
|
Model G0442/G0601 (Mfg Since 8/10) |