Multiquip EHTX44Y5 operation manual Dipstick

Page 49

 

TROUBLESHOOTING

 

 

 

 

 

 

 

Troubleshooting (engine) - continued

 

Symptom

possible problem

Solution

 

 

 

Low engine power output and low speed,

Air fi lter blocked?

Clean or replace air fi lter.

 

 

Incorrect valve clearances?

Adjust valves per engine specifi cation.

black exhaust smoke.

 

 

Malfunction at injector?

See engine manual.

 

 

 

 

 

Too much oil in engine crankcase?

Drain off engine oil down to uppermark on

 

dipstick.

 

 

 

 

 

 

Entire cooling air system contaminated/

Clean cooling air system and cooling fi n

 

blocked?

areas.

Engine overheats.

Fan belt broken or elongated?

Change belt or adjust belt tension.

Coolant insuffi cient?

Replenish coolant.

 

 

Radiator net or radiator fi n clogged with dust?

Clean net or fi n carefully.

 

Fan, radiator, or radiator cap defective?

Replace defective part.

 

Thermostat defective?

Check thermostat and replace if necessary.

 

Head gasket defective or water leakage?

Replace parts.

ehtx44y5 RIDE-ON TROWEL • operation manual — rev. #0 (01/16/13) — page 49

Image 49
Contents Model eHTX44Y5 Fuel and chemical exposure Warnings Respiratory Hazards Silicosis WarningEhtx Ride-On Trowel Page Completely Training checklistDaily pre-operation checklist Explosive fuel hazards SaFeTy meSSageSBurn hazards Rotating parts hazardsGeNeRaL SaFeTy ENgINe SaFeTy TROWeL SaFeTyOrder Form PT-160 Before servicing equipmentBaTTeRy SaFeTy FueL SaFeTy„ Use well-insulated gloves when picking up the battery „ NeveR lift trowel with the operator on the machine TRaNSpORTINg SaFeTy„ aLWayS shutdown engine before transporting EmISSIONS INFORmaTION ENvIRONmeNTaL SaFeTy/DeCOmmISSIONINgEmission Control Label Label must remain with the engine for its entire lifeEhtx DIMENSIONS/SPECIFICATIONSGuaranteed ISO 112012010 Based SpecificationsGuaranteed ISO 37442010 Based Sound Power Level in dBA bGeneral Information Hour Meter Indicates number of hours machine has been used Controls and Indicators25 20 Fuel Filter Removes dirt and water from the engine fuel Engine ComponentsTrowel Setup Instructions SetupSeat assembly Battery SetupHydrauic Oil Level InspectionEngine Oil Level FuelOperation Insert the ignition key into the ignition switch, FigurePlace the engine speed control lever, in the LOW position Place the engine speed control lever, in the High position SteeringBlade Pitch Control Trowel Speed Limiter ControlEngine Shut-Down Clean and remove any foreign debris from the troweMAINTENANCE Remove the air cleaner element Air CleanerOFF position Changing Engine Oil And Filter Checking Engine Oil DailyFilter element from the inside out Gal 9.5 liters Operation in Freezing WeatherVol % Freezing Point Boiling Point Anti 108 226Fuel Filter Radiator MaintenanceFuel/Water Separator Check and clean battery terminals for corrosion Battery/Charging SystemOil And Fuel Lines Checking The V-BeltChecking/Adjusting Trowel Speed Right Side Trowel Speed AdjustmentLeft Side Trowel Speed Adjustment Engine Tune-UpBlade Pitch Adjustment Bolt Blade Pitch Adjustment ProcedureChanging Blades Stabilizer Ring RemovalSpider Removal Trowel Arm AdjustmentPlace the trowel on a FLAT, Level surface Remove spider to hydraulic motor retainingscrew Trowel Arm RemovalRemove the trowel arm from the spider plate Checking Trowel Arm Straightness Locate the trowel arm adjustment tool P/NTrowel Arm Adjustment Fixture Components Re-AssemblyChecking Hydraulic Steering Pressure Installing Pans Onto Finisher BladesLifting/Crush Hazard. do not lift trowel with pans attached Hydraulic Pump Pressure Test Ports Checking Steering Pressure Steering Pressure AdjustmentCool Oil1 155-175 PSI Hot Oil 145-165 PSI Press the left pitch rocker switch downward Pitch Pressure Out of SpecificationPitch Pressure Check Pitch Pressure Adjustment Pitch Pressure AdjustmentSWITCH,KEY Wiring DiagramHydraulic Diagram Troubleshooting Ride-On Hydraulic Trowel TroubleshootingWiring? Troubleshooting engine Dipstick HERE’S HOW to GET Help