Multiquip EHTX44Y5 Operation, Place the engine speed control lever, in the LOW position

OPERATION

STARTING THE ENGINE

1.Place one foot on the trowel's platform, grab hold of the hand grip located on the front frame, and lift yourself onto the trowel, then sit down in the operator's seat. DO NOT use the joysticks to lift yourself onto the trowel.

NOTICE

Pulling on the joysticks repeatedly will weaken the units. ALWAYS use the grab handles to lift yourself on the trowel.

NOTICE

This trowel is equipped with a safety stop switch that will not allow the engine to start unless an operator is sitting in the operator’s seat. The weight of an operator depresses an electrical switch, which allows the engine to start.

WARNING

NEVER disable or disconnect the safety stop switch. It is provided for the operator's safety and injury may result if it is disabled, disconnected or improperly maintained.

NOTICE

The safety stop switch should be used to stop the engine after every use. Doing this will verify the switch is working properly thus providing safety for the operator. Remember to turn the key to the “OFF” position after stopping the machine. Not doing so may drain the battery.

2.It is recommended that the operation of the Safety Stop Switch is checked prior to performing any troweling operations. Doing this will verify that the switch is working properly contributing to safe operation of the machine.

3.Place the engine speed control lever, Figure 9 in the LOW position.

ENGINE SPEED

CONTROL LEVER

HI

GH

L

OW

Figure 9. Engine Speed Control Lever (Low)

4. Insert the ignition key into the ignition switch, (Figure 10)

T ER S

WIT

TAR

CH

S

CONTACT

ST

E

DE

A

G

RT

A

M

T

F

A

A

U

F

R

E

A

R

H

E

C

H

G

R

E

E

P

R

P

Figure 10. Ignition Switch and Key

5.Turn the ignition key clockwise to the (start) position. The oil and charge indicator lights, (Figure 11) should be on.

Figure 11. Oil and Charge Indicator Lights

NOTICE

OIL, and CHARGE, indicator lights come on when ignition switch is in the ON position, and the engine is NOT running. In COLD weather turn and hold the ignition key counter clockwise to the PREHEAT position, wait until the preheat indicator goes off before turning the ignition key clockwise to the start position. Two or three preheat cycles may be necessary in very cold weather.

page 22 — eHtx44y RIDE-ON TROWEL • operation manual — rev. #0 (01/16/13)