Black & Decker BDCMTOA instruction manual Functional Description, Symbols, Accessories

SYMBOLS

The label on your tool may include the following symbols. The symbols and their definitions are as follows:

V		volts	A		amperes
Hz		hertz	W		watts
min		minutes	no		alternating current
		direct current			no load speed
		Class I Construction			earthing terminal
	.................			..................
		(grounded)		.................	safety alert symbol
	.................	Class II Construction	opm		oscillations per minute
		(double insulated)
		.............Read instruction manual before use		..................	Use proper respiratory protection
	.................	Use proper eye protection		..................	Use proper hearing protection

•When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. The following table shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.

			Minimum Gauge for Cord Sets
Volts			0-25	Total Length of Cord in Feet
120V				26-50	51-100	101-150
240V			(0-7,6m)	(7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
			0-50	51-100	101-200	201-300
			(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Ampere Rating				American Wire Gauge
More		Not more
Than		Than	18	16	16	14
0	-	6
6	-	10	18	16	14	12
10 -		12	16	16	14	12
12 -		16	14	12	Not Recommended

SAVE THESE INSTRUCTIONS

FUNCTIONAL DESCRIPTION		6.	Plunge cut blade
1.	Oscillating tool attachment
2.	Accessory clamping lever	7.	Adapter plate
3.	Accessory holder	8.	Bolt and top plate
4.	Sanding platen	9.	Hex wrench
5.	Sand sheets
	4		5
	3
				8
	1			9
				7
			6

2

ACCESSORIES

Other oscillating tool accessories are available for a wide range of applications including scraping, drywall cutting, grout removal, thin set removal, and more. Please visit www.blackanddecker.com for more details.

4