PXGA Standard Grille
Installation Instructions
1.Remove the center support and weatherboard if still installed in the sleeve.
2.Insert six plastic grommets into the grille openings from the outside of the grille as shown in Figure 13.
3.Insert two #8 x ⅜" sheet metal screws (provided) in the top two outside edge plastic grommets, and tighten them half way into the grommets.
4.Grasp the grille by the attached plastic handles. Position it with the condensate drain knockouts facing down.
From inside the building, maneuver the grille through the wall sleeve and pull toward you until the screw heads are inserted into the keyhole slots at the top of the wall sleeve. Tighten the two screws completely.
5.Insert the remaining screws into the remaining holes and tighten securely.
WARNING
Falling Object Hazard
Not following Installation Instructions for mounting your air conditioner can result in property damage, injury, or death.
Figure 13 |
|
|
|
Standard Grille |
|
|
|
|
|
| WALL |
|
|
| SLEEVE |
|
|
| STANDARD |
|
|
| GRILLE |
|
| WEATHERBOARD | #8 x 3/8” |
|
| SHEET METAL | |
|
|
| |
|
|
| SCREW |
|
| CENTER SUPPORT |
|
WALL SLEEVE |
|
|
|
|
| STANDARD GRILLE |
|
| PXGA Standard Grille |
|
|
Quantity | Description |
|
|
1 | Stamped Aluminum Grille |
| PLASTIC GROMMETS |
6 | Plastic Grommets |
| |
|
| ||
6 | #8 x " Sheet Metal Screws |
| PLASTIC HANDLES |
|
|
| FRP013 |
12 |
|
|
|