Friedrich 920-087-09 operation manual To Chassis Junction

Figure 15

TO CHASSIS JUNCTION

Figure 16
	STRAIGHT
	CONNECTOR
WALL CONNECTION	JUNCTION
	BOX

TRIM HARNESS TO LENGTH

EXPOSE WIRES (1.0 IN.)

4.0 IN.

18.0 IN.

	GROUND
	SCREW
GROUND
WIRE
HARNESS
JUNCTION	COVER
	SCREWS
BOX COVER
	FRP033

Figure 17

STRIP WIRE ENDS (0.5 IN.)

TO WALL JUNCTION

FRP032

3.Route the cut ends of harness through the conduit connector assembly and flex conduit sleeve. Be sure to use the supplied conduit bushing to prevent damage to the cord by the conduit.

The cord should pass through the Locknut, Spacer, Chassis Junction Box, Conduit Connector, Bushing, then the Conduit Sleeve. See Figure 17.

4.Route the cut ends of the power cord through the elbow connector at the other end of the conduit. Tighten screws on elbow connector to secure conduit sleeve.

5.Fasten and secure the elbow connector to the wall junction box cover with locknut. Place and mount the wall junction box with the four wall mounting screws making sure to pass the wall lines through the junction box. Connect and join all wall lines with the stripped ends using wire nuts. Tighten both screws of the wall junction box cover to junction box.

6.Follow steps 4-6 on page 19 and refer to Figure 27.

	LEADING SIDE FOR
	WIRE HARNESS INSERTION
SPACER	LOCKNUT
	CHASSIS
	JUNCTION
SPACER	BOX

CONDUIT

CONNECTOR

BUSHING

CONDUIT

SLEEVE

EXITING SIDE FOR
WIRE HARNESS	FRP034

15