Kenmore 153.33262, 153.33264 manual Corrective Action

Page 37

continued:

PROBLEM

WATER LEAKS

LEAKING T&P

HOT WATER ODORS

WATER HEATER SOUNDS SIZZLING-RUMBLING

SMOKING AND CARBON FORMATION (SOOTING)

HIGH OPERATION COSTS

THERMOSTAT FAILS TO

SHUT-OFF

DRIP FROM RELIEF VALVE

POSSIBLE CAUSE(S)

1.Improperly sealed, hot or cold supply connections, relief valve, drain valve or thermostat threads.

2, Leakage from other appliances or water lines.

3.Condensation of flue products.

4.Excessive water pressure.

5.Heater stacking.

6.Closed water system.

1.Thermal expansion in closed water system.

2.Improperly seated valve.

1.High sulfate or mineral content in water supply.

2.Bacteria in water supply.

1.Condensation dripping on burner.

2.Sediment at bottom of heater tank.

1.Insufficient secondary air.

2.Low gas pressure.

3.Water heater flue or vent system blocked.

4.Thermostat not functioning properly.

5.Heater installed in a confined area.

6.Burner flame yellow-lazy.

1.Thermostat set too high.

2.Sediment or time in tank.

3.Water heater too small for job.

4.Wrong piping connections.

5.Leaking faucets.

6.Gas leaks.

7.Wasted hot water.

8.Long runs of exposed piping.

9.Hot water piping in exposed wall.

1.Thermostat not functioning properly.

2.Improper calibration.

1.Excessive water pressure.

2.Heater stacking.

3.Closed water system.

CORRECTIVE ACTION

1.Tighten threaded connections.

2.Inspect other appliances near water heater.

3.See "START UP CONDITIONS", section.

4.Use a pressure reducing valve and relief valve.

5.Lower the thermostat setting.

6.See "Closed System/Thermal Expansion".

1.Install thermal expansion tank (DO NOT plug T&P valve).

2.Check relief valve for proper operation (DO NOT plug T&P valve.

1.Drain and flushing heater thoroughly then refill.

2.Chlorinate water supply.

1.See "START UP CONDITIONS", section.

2.See "DRAINING AND FLUSHING", section.

1.Provide ventilation to water heater. Check flue way, flue baffle, burner.

2.Check with gas utility company.

3.Clean, locate source and correct.

4.Replace thermostat.

5.Provide fresh air ventilation.

6.See "Burner Flame Yellow-Lazy".

1.Set temperature to lower setting.

2.Drain/flush-provide water treatment if needed.

3.Install adequate heater.

4.Correct piping-dip tube must be in cold inlet.

5.Repair faucets.

6.Check with utility-repair at once.

7.Advise customer.

8.Insulate piping.

9.Insulate piping.

1.Replace thermostat.

2.Replace thermostat.

1.Use a pressure reducing valve and relief valve.

2.Lower the thermostat setting.

3, See "CLOSED SYSTEM/THERMAL EXPAN- SION", section.

37

Page 36 Page 38
Image 37
Page 36 Page 38
Contents 317997-000 =I=€di,lldImportant Definitions Read and follow water heater warnings and instructionsFire or Explosion Hazard Improper installation and use may result in property damageFire Hazard Explosion HazardClearances Accessibility High Altitude Installation InstallationVent Connectors Chimney Get to know your Water HeaterPoweredAnodeRodOperation ElectricalConnections SolarInstallation WiringDiagramMaster Protection Agreements Sears Installation ServiceImportant Information About This Water Heater Excessive Weight HazardNatural 40,000 42.6 153.332620153.332640 189 Natural 40,000 42.6 376or4102 559 57.13 1451 Materials Needed Transformer SwitchGas Supply Piping Pressure Relief ValveWater Heater Location Installation ChecklistCombustion Air Supply and Ventilation Vent Pipe SystemManualgas Removing the Old Water HeaterSite Location Location RequirementsCarbon Monoxide Poisoning Hazard SensorPmpey Damage Hazard High Altitude InstallationMinimum Clearance Locations Gas Pressure Gas Requirements Gas Pressure TestingGas Piping Explosion HazardAtuml Gas Pipe Capacity Table Cue FtJHr Gas Pipe Capacity TableConfined Space Unconfined SpaceCarbon Monoxide Warning Louvers and Grilles All Air from the BuildingAll Air from Outdoors Minimum FreeVent Pipe System Draft Hood InstallationAll Air from Outdoors Through Ventilated Attic Vent Pipe Size Vent ConnectorsChimney Connection Vertical Exhaust Gas VentVenting Gas Vent System With Type B Double Wall Vent Pipe Piping InstallationClosed System/Thermal Expansion Pmpey Damage Hazard Temperature and Pressure Relief ValveRelief Valve and Pipe Insulation Temperature Pressure Relief ValveDischarge Line Electrical Connections Solar InstallationOperating Instructions Manual before changing temperatureFailure to do so can result in death Explosion or fire Replace view port if glass is missing Or damagedChecking the Draft Water Heater OperationBurn Hazard Do not touch vent Doing so can result in burnsBurner Flames Water TemperatureEmergency Shut Down RegulationPowered Anode System Powered Anode OperationHotter J Routine Preventive Maintenance Temperature and Pressure Relief Valve Explosion HarzardDraining and Flushing Removing the Burner from the Manifold/ Burner Assembly Replacement PartsRemoving the Manifold/Burner Assembly Replacing the Flame Sense/Hot Surface igniter AssemblyReplacing the Manifold/Burner Assembly Cleaning the Combustion Chamber and Air Diverter AssemblyDoor Gasket Burner ISlot Viewport Removing and Replacing the Gas Control Valve/ThermostatReplacing the Gas Valve Start Up Conditions Condensation Safety Shut-off and Thermal SwitchSmoke Odor AIR In Hot Water FaucetsLeakage Checkpoints Possible Causes Pressurized Combustion Chamber System Operational ChecklistCorrective Action Power IGN Heating Clean SW, OPEN, and Clean Screen Flashing Open YES Key Parts Description Pressurized Combustion Chamber153.332620 153.332640 Page Managemylife
Related manuals
Manual 44 pages 10.06 Kb

153.33262, 153.33264 specifications

The Kenmore 153.33262 and 153.33264 are highly versatile and efficient portable air conditioners designed to provide optimal cooling solutions for indoor spaces. These models stand out in their class due to their advanced features, technologies, and user-friendly characteristics, making them suitable for a variety of environments, from small apartments to large rooms.

One of the primary features of both the Kenmore 153.33262 and 153.33264 is their high cooling capacity. With powerful BTUs, they can effectively cool spaces up to a specified square footage. This capability ensures that users can maintain a comfortable indoor climate even during the hottest summer months. Their energy efficiency is another notable aspect, allowing homeowners to enjoy cooler air without incurring exorbitant energy bills.

The two models are equipped with various modes of operation, including cooling, fan, and dehumidifying modes. This multifunctionality allows users to customize their comfort based on prevailing weather conditions. For instance, the dehumidifying mode effectively reduces excess moisture in the air, creating a more comfortable environment, particularly in humid regions.

Both air conditioners come with a user-friendly digital interface that features an easy-to-read LED display. The interface allows for straightforward adjustments to the temperature, fan speed, and operating modes. Furthermore, remote control functionality enhances convenience, enabling users to change settings from across the room.

In terms of technology, these models incorporate a self-evaporating system that minimizes the need for manual water drainage. This feature is particularly advantageous for users who prefer low-maintenance options. Additionally, both units feature a washable air filter, designed to capture dust and allergens, improving air quality and ensuring that the units operate efficiently.

Portability is another significant characteristic of the Kenmore 153.33262 and 153.33264. Built-in caster wheels and side handles allow for easy movement from room to room, making them ideal for temporary cooling needs. The easy installation process and included window exhaust kit mean users can set up the units quickly without requiring professional assistance.

In conclusion, the Kenmore 153.33262 and 153.33264 portable air conditioners offer a robust combination of high cooling performance, energy efficiency, and user-friendly features. Their advanced technologies and versatile functionalities make them an ideal choice for those seeking effective indoor air conditioning solutions.
Top Page Image Contents