Miller Electric D-75S, D-75D manual Trigger Hold Switch, Voltage Control And Digital Meters

6-4. Trigger Hold Switch

1 Trigger Hold Switches

Trigger hold allows the operator to weld without holding the gun trigger.

• To use the trigger hold function, place the trigger hold switch in the On position.

• The operator must hold the trig- ger for a minimum of 2 seconds, but not longer than 6 seconds be- fore releasing it. Welding will con- tinue when the trigger is re- leased.

• To stop welding, press the trigger again.

1

Ref. 804 568-B

6-5. Voltage Control And Digital Meters

1 Voltmeter

1

2

3

Displays actual or preset voltage from welding power source through the 14−pin control cable.

.Voltmeter will not display actu-

al or preset voltage if voltage feedback is not provided through the 14-pin control cable.

2 Wire Speed Meter

Displays preset and actual wire feed speed while welding.

Factory set to display inches per minute. If display of meters per min- ute is desired, see Section 5-12.

3 Voltage Controls

Use controls to adjust voltage out- put of welding power source.

.You can adjust the preset volt-

age display on the wire feeder to match your power source’s display by adjusting P2 on mo- tor control board PC101 (left side), and/or P2 on motor con- trol board PC1 (right side). See Section 7-3for location of P2.

Ref. 804 567-B

OM-228 322 Page 22