Simer Pumps 3410P, 3415P, 3420P owner manual Table of Contents

Page 3

Table of Contents

3

Thank you for purchasing a top quality, factory tested pump.

 

 

Page

General Safety

2

Warranty

3

Installation

4,5

Electrical

6,7

Operation

8,9

Troubleshooting

9

Repair Parts

10

RETAIN ORIGINAL RECEIPT FOR YOUR RECORDS.

LIMITED WARRANTY

SIMER warrants to the original consumer purchaser (“Purchaser” or “You”) of its products that they are free from defects in material and workmanship for a period of twelve (12) months from the date of the original consumer purchase.

If, within twelve (12) months from the original consumer purchase, any such product shall prove to be defective, it shall be repaired or replaced at SIMER’s option, subject to the terms and conditions set forth below. The original purchase receipt and product warranty information label are required to determine warranty eligibility. Eligibility is based on purchase date of original product – not the date of replacement under warranty. The warranty is limited to repair or replacement of product only – Purchaser pays all removal, installation, labor, shipping, and incidental charges.

For parts or troubleshooting assistance, DO NOT return product to your retail store. Contact SIMER Customer Service at 1-800-468-7867 / 1-800-546-7867.

Claims made under this warranty shall be made by returning the product (except sewage pumps, see below) to the retail outlet where it was purchased immediately after the dis- covery of any alleged defect. SIMER will subsequently take corrective action as promptly as reasonably possible. No requests for service will be accepted if received more than 30 days after the warranty expires.

SEWAGE PUMPS

DO NOT return a sewage pump (that has been installed) to your retail store. Contact SIMER Customer Service. Sewage pumps that have seen service and been removed carry a conta- mination hazard with them.

If your sewage pump has failed:

• Wear rubber gloves when handling the pump;

• For warranty purposes, return the pump’s cord tag and original receipt of purchase to the retail store;

• Dispose of the pump according to local disposal ordinances.

Exceptions to the Twelve (12) Month Limited Warranty

 

 

Product

Warranty Period

 

BW85P, CM10, CMK, M40, M40P

90 days

 

 

2300, 2310, 2330, 2520ULST, 2943, 2955, 2956, 2957, 2960, 5023SS, A5500

2 Years

 

 

 

 

 

 

4” Submersible Well Pumps, 2945, 2958, 2975PC, 2985, 3075SS, 3983, 3984

3 Years

 

 

 

 

 

 

Pre-Charge Water System Tank, 3985, 3986

5 Years

3963, 3988, 3995, 3997

Lifetime

 

 

 

 

General Terms and Conditions

You must pay all labor and shipping charges necessary to replace product covered by this warranty. This warranty does not apply to the following: (1) acts of God; (2) products which, in SIMER’s sole judgement, have been subject to negligence, abuse, accident, misapplication, tampering, or alteration; (3) failures due to improper installation, operation, maintenance or storage; (4) atypical or unapproved application, use or service; (5) failures caused by corrosion, rust or other foreign materials in the system, or operation at pressures in excess of recommended maximums.

This warranty sets forth SIMER’s sole obligation and purchaser’s exclusive remedy for defective products.

SIMER SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL, INCIDENTAL, OR CONTINGENT DAMAGES WHATSOEVER.

THE FOREGOING WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESS AND IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WAR- RANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. THE FOREGOING WARRANTIES SHALL NOT EXTEND BEYOND THE DURATION PROVIDED HEREIN.

Some states do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above limitations or exclu- sions may not apply to You. This warranty gives You specific legal rights and You may also have other rights which vary from state to state.

SIMER • 293 Wright St., Delavan, WI U.S.A. 53115

Phone: 1-800-468-7867 / 1-800-546-7867 • Fax: 1-800-390-5351

Web Site: http://www.simerpumps.com

Image 3
Contents Composer le 1 800 Llame al English Pages 2-10 FrançaisEspañol General Safety SafetyRead and Follow Safety Instructions Electrical SafetyTable of Contents Cased WELL/DUG Well Installation InstallationBefore YOU Install Your Pump Well Pipe InstallationDischarge Pipe Sizes PUMP/PIPING InstallationDriven Point Installation Horizontal Piping From Well to PumpSelecting Voltage with Dial Type Voltage Selector Motor Switch SettingsElectrical Remove Motor END CoverConnections WiringPriming the Pump OperationPerformance Chart / Gpmlpm TroubleshootingPart Names Repair Parts’alimentation électrique SécuritéTable des matières Installation 13,14 Électricité 15,16 Fonctionnement 17,18Vant D’INSTALLER LA Pompe Installation DE LA Tuyauterie DU PuitsInstallation Puits CUVELÉ/CREUSÉ Tuyauterie Horizontale Entre LE Puits ET LA Pompe Calibre DU Tuyau DE RefoulementApplication DE LA Pompe D’ARROSAGE Réglages DU Moteur ÉlectricitéCâblage Amorçage DE LA Pompe FonctionnementTable des rendements / Gpmlpm Diagnostic des pannesRéf Des pièces 60 Hz/1 Ph Pièces de rechangeNom des pièces 3410P 3415P 3420P 2 ch Désignation 115V/230VSeguridad General SeguridadLEA Y Siga LAS Instrucciones DE Seguridad Seguridad ElectricaInstalación 22,23 Electricidad 24,25 Operación 26,27 Indice de ContenidoInstalación Antes DE Instalar LA BombaInstalación DEL Tubo EN EL Pozo Tamaños DE LOS Tubos DE Descarga Instalación DE LA Bomba Y TuberíasInstalación EN Pozos CON Tubería Hincada Tubería Horizontal DEL Pozo a LA BombaSaque LA Tapa DEL Motor Configuraciones DEL Interruptor DEL MotorConecte el motor a tierra antes de conectarlo al sumin CableadoCebado DE LA Bomba OperaciónCuadro de funcionamiento / Gpmlpm Solución de ProblemasDe las Piezas 60 Hz/1 Ph RefaccionesNombres de las Piezas 3410P 3415P 3420P 2 HP Nde Descripción 115V/230V

3420P, 3415P, 3410P specifications

Simer Pumps has long been recognized as a leader in the domain of portable pumping solutions, with a strong reputation built on consistent reliability and innovative technologies. Among their well-regarded offerings are the Simer Pumps 3420P, 3410P, and 3415P models, each designed to meet diverse pumping needs across various applications.

Beginning with the Simer Pumps 3420P, this model is engineered for high efficiency and robust performance in both residential and light commercial settings. One of its standout features is a powerful motor that delivers excellent flow rates, making it ideal for tasks such as dewatering, draining pools, and managing flooded basements. The 3420P also includes a durable thermoplastic construction, ensuring resistance to corrosion and long service life. Additionally, its built-in thermal overload protection prevents overheating, allowing users to operate the pump with peace of mind.

Next, the Simer Pumps 3410P has earned accolades for its user-friendly design and versatility. This pump is particularly suited for applications such as lawn irrigation and general water transfer. The 3410P features an adjustable flow rate, allowing users to customize operation according to specific needs. A unique feature of this model is its lightweight construction, making it easy to transport and set up in different locations. Its compact design does not compromise its capacity, ensuring efficient operation regardless of the task at hand.

Finally, the Simer Pumps 3415P exemplifies reliability and innovation, perfect for demanding applications. This model is designed to tackle tougher jobs and handle larger volumes of water with ease. It features an integrated float switch that automates operation, meaning it will activate when water levels rise and deactivate once levels return to normal. The 3415P is also equipped with an advanced motor that operates efficiently, even during prolonged use, showcasing Simer's commitment to energy efficiency.

In terms of technological advancements, all three models benefit from Simer’s focus on durability and efficiency. These pumps utilize state-of-the-art materials and manufacturing processes that not only enhance performance but also extend product longevity. Users can expect these pumps to deliver optimum results with minimal maintenance requirements.

In summary, the Simer Pumps 3420P, 3410P, and 3415P offer a variety of features that cater to a range of pumping needs. With their robust construction, efficient operation, and user-friendly designs, these pumps represent an excellent choice for both residential and commercial users looking for reliable water management solutions. Simer Pumps continues to innovate, ensuring they remain a trusted name in the pumping industry.