Harbor Freight Tools 91130 Assembly Instructions, Assembly Diagrams on pages 28, 29, 30, 31

Page 12

ASSEMBLY INSTRUCTIONS

NOTE: For additional references to the parts listed in the following pages, refer to the

Assembly Diagrams on pages 28, 29, 30, 31, and 32.

To Assemble The Base:

1.Place one Table (8A) upside down on a level floor surface. Attach a Support Board 1 (2A) to opposite corners of the Table, and attach a Support Board 2 (1A) to the two remaining opposite corners of the Table using Screws (3A), Washers (6A), and Plastic Nuts (7A). Repeat this procedure for the remaining two Tables (8A). (See Figure F.)

2.Hold Support Leg 1 (4A) and Support Leg 2 (9A) together with their mounting holes aligned. Then, align the mounting holes of the Support Legs with the three mounting holes in Support Board 1 (2A) and Support Board 2 (1A). Secure the Support Legs to the Support Boards, using Screws (3A), Washers (6A), and Plastic Nuts (7A). (See Figure F.)

 

 

 

SUPPORT LEG 2

SCREW (3A)

 

 

SUPPORT LEG 1

 

(9A)

 

 

 

WASHER (6A)

 

 

 

(4A)

 

 

 

 

END

 

 

 

 

PLASTIC NUT (7A)

 

 

 

 

 

 

 

 

 

 

VIEW

 

 

 

 

 

 

 

(UPSIDE DOWN)

TABLE (8A)

FRONT

VIEW

(UPSIDE DOWN)

TABLE (8A)

TABLE (8A)

SUPPORT

SUPPORT

 

BOARD 2

BOARD 1

FIGURE F

(1A)

(2A)

 

FRONT

VIEW

(RIGHT SIDE UP)

SKU 91130

For technical questions, please call 1-800-444-3353.

Page 12

Image 12
Contents For technical questions or replacement parts, please call Router with Full Size TableProduct Specifications General Safety RulesUnpacking Save this ManualElectrical Safety Personal SafetyTool USE and Care Specific Safety Rules ServiceSKU For technical questions, please call Page Page Grounding Grounded Tools Tools with Three Prong PlugsExtension Cords Double Insulated Tools Tools with TWO Prong PlugsSee Figure C, next See Figure CSymbology Figure CProduct Features Figure EAssembly Instructions Assembly Diagrams on pages 28, 29, 30, 31,To Assemble The Base To Assemble The Mid-Section See Figure GFront View To Attach The Mid-Section To The Body See Figure HSee Figure I, next To Attach The Main TableSee Figure J Figure JTo Attach The Motor Assembly To Attach The FenceSee Assembly Diagram C and Figure L See Assembly Diagram CTo Attach The Dust Port Assembly And Protector See Assembly Diagram C and Figure M To Install And Remove ColletsSee Figure N, next Figure N To Adjust The Depth Of Cut See Figures K and PTo Attach And Adjust The Feather Boards Figure RSee Figure S To Attach The Miter GaugeTo Adjust The Upper Fence To Adjust The Speed RPMSee Figure U To Turn On The Router Table To Operate The Router TableINSPECTION, MAINTENANCE, and Cleaning Please Read the Following CarefullyDo not use damaged equipment Parts List a Parts List BParts List C Parts List D Parts List EAssembly Diagram a Assembly Diagram B Assembly Diagram C Assembly Diagram D Assembly Diagram E