4.NOTE: For more convenience when making miter cuts, the Upper Fence (16C) may be moved to its furthest position away from the router bit. (See Figure T.)
|
|
| MAIN TABLE (20B) |
|
|
| FENCE ADJUSTING | ||||
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| KNOB |
|
|
|
|
|
|
|
|
|
|
| (13C) |
MITER GAUGE |
|
|
| ||||||||
CHANNEL |
|
|
|
|
| UPPER FENCE (16C) | |||||
|
|
| |||||||||
MITER GAUGE |
| ||||||||||
| |||||||||||
|
|
| |||||||||
(27C) |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
| |||||||
FENCE |
|
|
|
|
|
|
|
|
| ||
|
|
|
|
| |||||||
LOCK |
|
|
| ||||||||
KNOB |
|
|
| ||||||||
(8C) |
|
|
| ||||||||
|
|
|
|
|
|
|
|
|
|
| FIGURE T |
|
|
|
|
|
|
|
|
|
|
|
|
To Adjust The Upper Fence:
1.The Upper Fence (16C) can be adjusted according to the size of the workpiece and the application being performed. To do so, loosen the four Fence Adjusting Knobs (13C). (See Figure T.)
2.Slide the Upper Fence (16C) forward or backward to the desired position.
Use the gauge on the Main Table (20B) to determine the distance from the Upper Fence to the center of the router bit. Then, retighten the four Fence Adjusting Knobs (13C). (See Figure T.)
To Adjust The Speed (RPM):
1.NOTE: Using the correct speed for the job increases the life of the router bit and can also affect the surface finish on the workpiece being cut. The Router Table features a Variable Speed Adjustment (28B) and may be adjusted from approxi- mately 8,400 RPM to 27,800 RPM (no load). (See Figure U, next page.)
2.The Dial of the Variable Speed Adjustment (28B) is numbered from 1 to 6, with 1 being the slowest speed and 6 being the fastest speed. It is recommended to determine the optimum speed by making a trial cut in a scrap piece of wood.
(See Figure U.)
3.IMPORTANT: Do not attempt to adjust the speed while the Router Table is running. Turn off the machine, and allow it to come to a complete stop before adjusting the speed. (See Figure U.)
SKU 91130 | For technical questions, please call | Page 23 |