Harbor Freight Tools 91130 operating instructions See Assembly Diagram C and Figure L

Page 17

2.Position the Upper Fence (16C) on the Main Table (20B).

3.Use two Screws (9C) to attach a Fence Support (10C) to the back of the Upper Fence (16C), making sure to use two of the outermost pre-fitted Nuts (11C) in the channel of the Upper Fence. Do not tighten yet. Repeat this procedure for the remaining Fence Support (See Assembly Diagram C.)

4.Slide the two Fence Supports (10C) along the Upper Fence (16C) until the hole in the horizontal leg of the Fence Supports is above the transverse (right angle) channel at the rear of the Main Table (20B).

(See Assembly Diagram C and Figure L.)

TRANSVERSE CHANNEL

MAIN TABLE

(20B)

TRANSVERSE

CHANNEL

FIGURE L

5.NOTE: The screw heads of the Screws (22C) locate in a channel under the Main Table (20B). This channel holds the Screws and prevents the Screws from turning when the Fence Locking Knobs (8C) are tightened or loosened.

(See Assembly Diagram C.)

6.Insert the screw head of a Screw (22C) into the channel under the Main Table (20B) so that the threaded portion of the Screw passes through the hole in a Fence Support (10C). Tighten the Screw, using a Fence Lock Knob (8C) and Large Washer (7C). (See Assembly Diagram C.)

7.Tighten the Screws (9C) holding the Fence Support (10C) to the Upper Fence (16C). (See Assembly Diagram C.)

8.Repeat Steps #6 and #7 at the other end of the Upper Fence (16C).

To Attach The Dust Port Assembly And Protector:

1.Position the Dust Port Assembly (26C) and Protector (23C) to the middle of the

SKU 91130

For technical questions, please call 1-800-444-3353.

Page 17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Router with Full Size Table For technical questions or replacement parts, please callGeneral Safety Rules Product SpecificationsUnpacking Save this ManualPersonal Safety Electrical SafetyTool USE and Care SKU For technical questions, please call Specific Safety RulesService Page Page Grounded Tools Tools with Three Prong Plugs GroundingDouble Insulated Tools Tools with TWO Prong Plugs Extension CordsSee Figure C, next See Figure CFigure C SymbologyFigure E Product FeaturesTo Assemble The Base Assembly InstructionsAssembly Diagrams on pages 28, 29, 30, 31, Front View To Assemble The Mid-SectionSee Figure G See Figure H To Attach The Mid-Section To The BodySee Figure I, next To Attach The Main TableFigure J See Figure JTo Attach The Fence To Attach The Motor AssemblyTo Attach The Dust Port Assembly And Protector See Assembly Diagram C and Figure LSee Assembly Diagram C See Figure N, next See Assembly Diagram C and Figure MTo Install And Remove Collets Figure N See Figures K and P To Adjust The Depth Of CutFigure R To Attach And Adjust The Feather BoardsTo Attach The Miter Gauge See Figure SSee Figure U To Adjust The Upper FenceTo Adjust The Speed RPM To Operate The Router Table To Turn On The Router TableDo not use damaged equipment INSPECTION, MAINTENANCE, and CleaningPlease Read the Following Carefully Parts List C Parts List aParts List B Parts List E Parts List DAssembly Diagram a Assembly Diagram B Assembly Diagram C Assembly Diagram D Assembly Diagram E
Top Page Image Contents